Search results

Thanks for reply guys. No washer came with it. And d manual has no spec on what one to use. Will probably just have to physically compare. There was a drip coming from it so if it has a washer it is probably defective. Ya was thinking about PTFE too but just wanted know should a washer be used...

Thanks for reply guys. No washer came with it. And d manual has no spec on what one to use. Will probably just have to physically compare. There was a drip coming from it so if it has a washer it is probably defective. Ya was thinking about PTFE too but just wanted know should a washer be used...

Hi guys I bought this part for a boiler, part no. 5114725. It came with no gasket. Do I need a gasket or does it connect to the diverter valve body as is?

Hi guys had a look at a baxi 33he boiler, was told it was ok for central heating but not heating dhw. I guessed it could be the diaphragm attached to the diverter valve but this boilers diverter valve is differently laid out to the other versions I have seen. Is there anyway to change out a part...

Ok aftter a bit more time with this problem.. I noticed the issue was not the fan but sounded as if it was in the combustion chamber. I then tried vent the boiler for air as it was running an noticed the water almost instantly turned to steam. So that indicated to me the issue was with...

Sorry about that, thanks for helping out.. I am not registered albeit I have completed the rgi and oftec, So will not endeavour into the areas of the boiler that I am not certified too.. Main thing I need to know is does this problem seem to be a direct boiler type problem or plumbing to the...

Is my fault common.. Whats the cc?

what about you pete any knowledge to share on the matter.. Im kinda lost, but i didnt think the boiler would fire up if there was an issue with the fan.

That was my first guess aswell and it seems to be in the exact area where the fan is.. Is there anyway of resolving this...? When it happens the boiler wont fire back up until the heat exchanger starts cooling.

Hi guys I tried fire up a potterton prima 50 F today, it has not been used for over a year and half eventually lt fired up but after a minute or so there was a grinding type noise coming from the top of the boiler any ideas on what this maybe.[/u]

I will add you as a friend so. is that ok.

ya spot on sure the boiler doesnt even fire up. Will isolating the main and running hot tap be sufficient in the removal process.. Or will have to drain down further.?

would this fault prevent led from working too.

Hi guys I was looking at one of these boilers earlier... When you draw off a hot tap the water stays cold and the led doesnt light up on the boiler any ideas of what this fault could be..

yes exactly so no need for that safety then is there...

sweet.. should i leave the safety on it and just add a vessel...

I cant be certain but think its a potterton prima f.... The safety is on pipework coming off boiler so why would that effect it if i where to seal it??

So you got no theory on it??

So in theory should work. I had another topic open based on the f&e tank only having 15mm cold feed but no vent, Im coming to the conclusion its a combined system but with plumber deciding NOT to do it in 22mm,, the boiler has a safety valve coming off the boiler so maybe he thought this was...

Hi guys I need to run the open vent and cold feed coming off the flow pipe of a boiler approx. 3 metres.. will this be a problem... Initially they will raise up flow pipe about a 1metre but then need to run horizontally for the 3 metres or so and then raise up again to attic.