Search results

This is the part you need.. remove the motor and then remove the silver clip behind the motor and pull the diverter valve out and replace.. you might need to remove the pressure sensor to get the silver diverter valve clip off

I don't dabble with bio mass or oil but your question doesn't make a lot of sence.. Care to elaborate?

All done thanks guys.. Worked fine when cleaned and dried.

That's why I do.. Never had an issue

It was an assumption on the photo you provided and mentioning there were no markings on the fitting (old hep2o fittings didn't have the brand printed on it either) also the metal insert and grab ring looks like the hep2o system.. I could well be wrong, But if your making alterations as long as...

That's the old style hep2o pipe.. Doesn't matter what fittings you use on it as long as the inserts are the same make

Yes should be fine.. Just check that the solder runs ok

That is the one I just bought to and it works great

Already entered my details for that one.. Just waiting for the powers to be to activate it.. But I'm kind of thinking washing the trap out has made it wet so it needs time or a hair dryer to dry it out.. I'm going out tomorrow to check it over

I would still list it as NCS on the cp12 just to cover yourself

ok guys, I am a RGI, but my friend is'nt. was just trying to save myself a trip out there. i have just never come across the sensor in one go faulty before

a friend of mine called me as his boiler is not working (main 24 he) seemed like a condense blockage so i talked him through cleaning the trap out which was filthy. now he says it works fine with the sensor wires disconnected but when he connects them it cuts out again (red light permanently on)...

Ahh ok thanks.

Hi guys, I have just entered my rgi info to get on to the combustion chamber forum. Is there a delay until it works.. When ever I click on combustion chamber it just shows me the page with the details I entered

i did run it for a day beforehand.. maybe needs a week or so. only noticed today my analyser would not read 0.008 as the maximum cut off for boilers. without wanting to sound stupid i presume 0.0080 is the same reading? Ive never had a reading before that is'nt 0.000 someting Bloody zeros get...

So ive just commissioned a new boiler and even though the mi's don't require a fga test for commissioning i always do one anyway.. however this one seems a bit high. what do you guys think Baxi neta-tec 28kw o2 % 4.7 c02% 9.2 co ppm 117 co/co2 0.0012 i usually get a 0.0006 out of...

ok thanks guys, i'll definatly get that book cs30, i did buy one when i first went self employed from corgi but it was'nt any good

right thanks, i do know the basic procedure like you just mentioned and am competent in replacing the parts when i'm sure it is faulty. i'm just paranoid of fault finding the wrong part and spending cash on parts that don't solve the problem.. i fit baxi's so may see if i can get on there...

Hi all this is my first post. i am a fully qualified corgi reg installer but have served all my time doing new builds so have never really got involved in the fault finding and servicing combis sort of work. need to top up my skills in this area so can any of you reccommend a course in the...

you should be able to get a new diaphram for the diverter reletavly cheap, should do the trick