Search results

I am just in the process of fitting a manrose 100mm centrifugal fan. The instruction say that i should connect the the ducting going out through the wall to to the end of the fan where the blade is visible. However the air flow arrow on top of the casing shows that if it was fitted this way...

I am just in the process of fitting a manrose 100mm centrifugal fan. The instruction say that i should connect the the ducting going out through the wall to to the end of the fan where the blade is visible. However the air flow arrow on top of the casing shows that if it was fitted this way...

I have recently converted half my internal garage in to a utility room. The garage floor was 7 inches lower than the adjoining kitchen. I have used treated timber and made a timber frame on top of DPC. With insulation in between the joists. Then used 18mm tongue and groove boards. This i...

Im in the middle of converting half the garage into a utility room I have made a treated timber frame to raise the garage floor up to the level of the rest of the house. The floor is vented underneath. Not sure what type of insulation to use, was going to use 75mm jablite, is this ok. Also...

Thanks what 2 inch insulation do u suggest. do i then need a vapour barrier on top of it all

Three sides of the floor will be against the internal walls of the garage. And the fourth will going into remainder of garage. I was going to build a stud partition wall. How do i ventilate the floor Also do i need to use any specific insulation in the wall or any particular type of plasterboard

Hi im about to start converting half my garage into a utility room. It already has water and electrics already in there. The garage floor needs to be raised. It already has a concrete floor which i have been advised already has a dpm. I was going to do this by laying timber frame and putting...