Search results

I have a Miele dishwasher model 1022i that has been failing to start properly. The initial drain pump runs ok, then it stops with the drain/fill light flashing. 5 short and 1 long flashes. It will drain fine if I throw a bucket of water in there. I fitted a new partition kit - the old...

I've had one of my two Drayton Za5 valves micro switches stick on me yet again, this time resulting in the HW permanently stuck on. I'm pretty sure it's this because if I hit it with a hammer it goes off for a while! And I have 4 of these over the years fail with similar faults. My question is...

My circulation pump is continuously running. The HW and CH is otherwise working ie coming on and off as it should, but the pump stays on, and it never used to do this. The boiler is not staying on with the pump. It is operating as it should do when called for by HW and CH. I have had problems...

In my mother-in-laws house she has a problem where the stored hot water tank is overflowing. The ball cock has been adjusted several times and finally a plumber has diagnosed the fault to the thermostatic bath mixer. He says I need to fit a non return valve to preferably the hot side as the...

My hot water appears to be permanently stuck on. I've read through some posts on here and have an idea what the fault may be. I'm no expert but below is the info I have gathered:- - Gas fired boiler Glowworm Ultimate 60FF - Two 2 port Drayton ZA5 actuators, one downstairs, one in the loft by...

I have a Glowworm boiler, and no changes made recently. A few days ago my heating started coming on when set to hot water only regardless of the room thermostat setting. After reading posts on here it sounded like my motorised valve was sticking/bust. So I think I've found it and attached...