Search results

[/url] thanks for that Had a look nothing for multi-tool

But those are for a Dremmel? Ive got the "performance power" Will the dremmel bits fit? dont know :?:

The transformer has 240v input and 12v out for the lights Whats a driver? :?:

Assume junction box is for 240v? can I not run the 240v direct to the 240v input to the transformer without a junction box? 12v lights will be in series with each other....... up to the rating of the transformer?

I have bought a couple of lighting kits I want to install in the downstairs ceiling void I will only be putting 20w bulbs in or I am thinking of the new SMD type that only consume 1W Installed some upstairs (in the ceiling to the loft) and had no problem with these just screwed the...

Have a Performance Power 18v 0-20000 rpm minature multitool but have lost the collets so the chuck will not clamp on anything Think I originally bought it from B&Q but they dont sell the collets for the chuck Tried every shop I can think of and all internet searches but have drawn a blank...

[/url] Oh dear..... was thinking of a Flip say less than £150.00 as I am only renovating my house need both mitre and table May have to think again :?: Thanks for your advice :cry: :?

Hey thanks - thats just what I need - so from level to slight slope will be good 25mm over a length - great Thanks very much Pete :D

Thanks - that interesting - looks like I bought the right one Ta Pete

Thanks for your advice - whats this Freecycle stuff do I have to sign up for it? Would like it to go to someone else for free, just dont like the waste of equipment all the good makes seem expensive tho as I am only a DIY bloke Pete

Had a B&Q CLM210SMS compount Mitre saw and it worked OK for a couple of years The first time it stalled (when something got stuck between the guard and the blade) it mangles the spline gear on the end of the motor shaft Asked Performance Power Pro and others but no spares Before a check...

Dont want to pay Makita prices but want a reasonable priced Flip over Saw B&Q,Screwfix and so on only seem to sell the professional jobs and although a want a reliable one would like a reasonable price too Best I have found is "Silverline" but even thats over £200 - must I just buy a table...

Am putting square guttering around a garage flat roof (with a small angle at the apex) My question is what slope do I install the gettering at to make sure it drains into the water butt? - is there any reccomendations or standards? pete :D

Anybody any more ideas What about the thermistors? Understand you can test them room temperature 10-12 kohms heated up 3-4 kohms Will this give me a reliable test? What do the thermistors do? Help appreciated - thanks Pete

Hope it will last a bit longer Have tried everything to get the system clean - last year I bottomed the lot! took all the radiators off one at a time and flushed them out with everything I could get, even the power washer (boy that shifted some stuff) and Halstead recommended a rubber mallet...

Boiler installed in 2002 - think he has retired Decided on Halstead as they have a good spec and the system seemed simple - it ran OK for a few years - looking at this andother baord seems none of the domestic boilser are reliable? :(

Oh what a clever little man you are! - no help tho!

The hot water starts straight away usually then cuts out Checked both micro switchs with a meter and they work OK both flow switches seem to move to actuate the microswitches - this is on first fire up after switching off - then after the first cut out it gets erratic and sometimes the pump...

Have looked on this and other forums and this shutting down problem seems to be a common problem with Halstead Nobody has come up with an answer that works when both CH and DHW are shuuting down?

It started about a month or so ago and got progessivly worse