Search results

It's a potential solution assuming an engineer is willing to repair. Question was if engineers are happy to fit used parts though.

It would seem that the solenoid has failed. It's the red and white button type.

Question for the SAFE registered ... What's the general feeling about fitting used parts? My situation is the gas valve on a conventional boiler has packed up. It's an Ideal Concord brute supplying heating only to four floors. It is old but going strong. Replacing the boiler is not an option...

They're fitting PV now or heat pumps

You are correct. The CE mark is used to confuse on purpose. The difference is in the letter spacing. If you project the circle of the C forward, it will just touch the E in the quality mark. In the Chinese Export CE, the letters are much closer together. In any event, Auzie kettle with a...

Ok, so my grand plan is to seal some yet to be discovered gaps. Assume the likes of joist ends where they enter the masory and the wind whistles through after decades of shrinkage etc, and around windows when I peel off the UPVC trim the fitters used and I find gaps big enough to stick fingers...

Perhaps something you might want to look at to save a bit of manual tweaking

Late to the party but a simple question: do you have weather compensation on the boiler?

Thanks. It's a long and thin hallway so laying length ways would make it look longer and thinner.

I'm planning to fit engineered oak in our hallway. 14mm click together planks, running width ways. Is it the done thing to add anything to the joints to reduce the chance of water ingress?

The eternal question ... What's your got to caulk? Which one do you reach for that you trust not to shrink, pull away and takes paint without a grumble?

A few years ago I insulated the underside of the suspended timber floor in my hallway. Plan now is to float engineered oak on top to match other rooms. Now, I've been given a leftover roll of that foil used with underfloor heating and I'm seriously tempted to put it down just to add a tiny bit...

Curious one ... I was chatting with a friend who had an EICR done on an upstairs flat he wants to rent out. Meter cupboard is inside the kitchen and has a meter connected directly to the CU and the various circuits spider away from there. Sparky does his thing and nothing untoward was noted...

Yep, I want silicone

Has anyone found a good while silicone sealant that doesn't Shrink? I had to make a quick external repair less than a year ago. The Soudal I used went on well, but it's shrunk a good 10% and pulled away.

Any recommendations for adhesive that doesn't make you dizzy?

Hadn't considered that. Any reason why you'd go down that route?

I've some 14mm engineered oak flooring I intend to fit in our hallway. They are the click together boards and are 1090 long. The hall is 970 wide so they'll be fitted width ways rather than length ways. Current floor is a well ventilated suspended floor with insulation underneath and 18mm ply on...

By coincidence, I had experience of asbestos bitumen last year when I had to have a property surveyed and an asbestos management plan put in place. First off, asbestos bitumen was around 8% asbestos, not 1%. Over time it dries out and becomes brittle rather than sticky. However, even in it's...

Sorry, question from the audience ... Looking at that photo, is the supply coming into the isolator then feeding the three breakers, or is it feeding the RCCB which then feeds the breakers?