Search results

  1. M

    Adding RCB to lighting circuit at consumer unit

    Installed outside lamps using 1.5 SWA. The outside wiring is connected to a light switch located inside the house. The 1.5mm T&E from the switch is connected to SWA cable within the house using appropriate jointing box and cable glands. I have only just realised that the downstairs lighting...
  2. M

    Outdoor lights in PVC conduit ?

    Hi, :?: Need to install 3 outside lights. I appreciate that SWA cable is the best option the problem is that there is very little room in the base of the pedestal lamps to bring in SWA and install a suitable jointing box. as there will be 2 incoming SWA cables and the lamp cable at two of the...
  3. M

    Slate cement repair prior to Kingspan installation

    Hi, House aged about 1920, slate roof, externally the roof is in good condition. Part of the loft has previously been converted to a bedroom. prior to my purchasing the house. An extension off the loft has no insulation between the rafters. I intend to use Kingspan K7 100mm, I informed...
  4. M

    125 volt AC how come ?

    Hi, I'm in the process of replacing a bedroom light. I didn't install the wiring so I don't know if it is correct or not. There are about six wires connected into a terminal block mounted in the rose. Whilst the ceiling fitment is disconnected Son in Law paints ceiling and knocks out a loose...
  5. M

    Radiator in loft ?

    Hi All, I want to install a radiator into my loft, the existing hot water tank is located in the loft but is at floor height. Is it still possible to install a radiator in the loft without lifting the hot water tank above the height of the radiator. Any help appreciated Mal Dinsdale
  6. M

    Help !!...Blocked 15mm pipe behind shower tiling

    Hi, Hot water from mixer unit getting less over approx 1 year. Mixer valve is fully round to max hot. Isolated pump power supply, disconnected pump discharge and checked flow of cold water OK Checked flow of hot water from pump discharge OK Removed mixer guts and checked water at mixer...
  7. M

    How hot will it get ?

    Hi, :( I'm in the process of installing a built in oven with a microwave/cooker located directly above the oven and in the same unit. The builder has installed a standard cooker isolator switch on the wall and has left a 6mm tail to connect to the oven only, nothing for the microwave. The...
Back
Top