Search results

It's worth checking the quoted operating pressure of your basin and bath mixers - it's possible the 1m difference is the cause (that only adds 0.1bar) or maybe the basin one is faulty? I have a similar low pressure gravity system, and after much hunting have used Tavistock mixers on bath and...

Pleeease!

I am busy making a similar construction, so I'll share what I have done but also encourage other answers! 1. I plan to use 12.5 mm Aquapanel as it's more dimensionally stable than WBP Ply. But I'd buy it from Wickes as it's a bit cheaper. You can cut it with a sharp knife or a fine toothed...

I have a proprietary wet room floor former, and will be tanking over this and the walls (aquapanel) before tiling. The wet room floor area needs to be slightly larger than the former that I have. Am I better using thick WBP ply, aquapanel, or WBP ply AND aquapanel for this area? It will be...

Just noticed this on another post, from John45 (thanks John!). Might explain what PJF meant. I positioned my sensors away from anything high (which might block coverage). That means cats can't get too close and make a large IR "target". John45 Joined: 04 Nov 2009 Posts: 41 Location...

I have the K9's fitted throughout my house. We have two cats, and they have never triggered the alarm, even though they can (and do) climb. I did loads of research before fitting, and my understanding is that the PIR excludes animals by the size of the detected IR signal, rather than its...

Try http://www.barrier-components.co.uk/hardware_for_glass/shower_enclosures/support_bars or http://www.go2infinity.co.uk/Save-On-Shower-Tracking-s/67.htm With a bar, 90 degree angle, and glass support / clamp, you should be able to make this up. Have you thought about a support...

Sorry for my ignorance, but what is a "knuckle" bend? Does it just mean it goes through 90 degrees in a short distance?

It's the main bathroom. Also near our bedroom so we'd hear it!

I have a challenge regarding a bathroom refit! Not sure if this is a plumbing or carpentry prob. Here goes... The top of my current (11cm diameter) soil pipe runs parallel and between the floor joists. It's top is 6cm below the top of the floor joists. A branch then a 92.5 degree bend...