Search results

I have just fitted a 10.5 shower and the trip keeps on tripping the fuse is only a 30a so I know I prob need to replace could anyone please tell me the size fuse I need. Thanks _____________________ moderator please note 20 your post has been split

Sorry if i am confusing you The tank has a cold water storage but this does not feed any of the cold taps sorry plumbing isn't my thing. :oops: The piping is 22mm from the tank into the bathroom and i have fed from this to the basin,bath 15mm. 22mm then carries on downstairs. If it...

I didnt touch pipes in the roof the lead finished in a cuboard and unfortunately I do not have a cold water tank (sorry house a bit dated) The cold is directly from the main. How do I push up from the mains :shock: I sounds very painful

I have just fitted a new bathroom with many problems but finally all fittings are in bath, sink, shower and loo. Problem is I have ample supply of cold water but the hot water flow is very weak. The cold is fed from the mains, the hot is fed from the tank in the attic. the pipes from the...

Thanks, sorted used lead to copper compression fittings i left 22mm around bathroow to hot water tank and fed from that for sink etc can you cure leaks... only kidding but had a few

yes it is hot water tank boiler is 15mm to pipe from hot water tank then goes into bathroom with lead piping approx 22mm do i need a lead to copper compression fitting to join onto lead piping from cold system

Hi I need to change lead piping in the bathroow at the boiler it is 22mm copper can I change to 15mm to feed the bathroow or should I put 22mm

Can anyone help me. I am currently changing my Bathroom. All the piping is lead which I am going to change to copper the piping at the boiler is 22mm copper. Can I change the piping at the boiler to 15mm copper piping or do I need to run 22mm all the way through the bathroom.

Sorry forgot the wires were all 2.5mm thick and it was the metal box in the light switch which was in the wall behind the plasterboard. Thanks :wink:

thanks for your comments. Sadly it isn't as easy as a blown fuse. I have come to the conculsion I should of bought a different house. I think this is a much deeper problem, I have found that there must be a break in a wire somewhere. This is a part of the house which is a extension to...

In the socket there is only one set of wires but it is directly below the light socket and in the light socket there is two sets of wires as both were working in the summer and now both are not working as I said I am not a electrican but this house has many secrets and I have reason to believe...

Thanks for the replies, The house was built in the 1930 ? so new to me. The two blacks are in a block, and the BULB hasn't blown. I replaced the light fitting just in case and then purchased a Non contact power detector to check and I have found out there is no power to the light, switch and...

hi, I have recently purchased a house which has many electrical problems. One of which is a dimmer switch light which did wok but stopped recently so I decided to replace with a new normal one way switch. I remover the plate of the dimmer to find two red connected to the dimmer two blacks joined...