Search results

youll need a competent plumber to remove it.

could be that the secondry heat exchanger is choked up, needs taking out and flushing through.

clever.. trevor.. stix.. u got a double entry rad valve,, u must have microbore,, microbore is not friends with sludge as sludge beat up microbores mate at the foriegn heat exchange(r) open up valve ( and lockshield screw) a couple o time to free any muck, but dont think sludge is gonna like...

turn the boiler stat to off but keep heating from timer running and bleed from every orafice :shock:

yea :oops: thought he meant trevor

for an up & over £500 max

thermostatic valve??

u should always prime the pump( commissiong procedure in manual will say how) but as the pump ran ok b4 without air locking then it must have been primed(expell air), pointing towards an internal fault(warranty)

make sure hot and cold incoming to shower r right way rnd as some p. showers differ. if u r sure the pipework is set out ok(tritons usually work well regardless of pipework) id contact triton as its a new shower. if any inline filters r fitted then check they're clean

how did u come off the hot water cylinder?? off at 45degrees or so? with a slight loop to avoid air ingress,, if not could be air locking both hot & cold should be first feeds..

the zone valve isnt functioning the way it should, if u unscrew the side screw and lift off the metal cover u will se a roundish synchron motor , this is replacable, and quite easy to do, these motors are prone to burning out. £15 to buy, 5 mins to fit. or ill sort it for £150 :D

not sure u got stung there, but anyway, a service would be a good call, it would identify anything dangerous as well.

thanks for that, it sounds as if the assessor wouldnt be over concerned on that point then!!!(but knowing my luck!!)

thats the criteria of corgi, to b assessed i have to show him some electrical work( in this case the radial to the immerssion on the megaflo i fitted), but the work had to b certified by a registered sparky..(funny i know) so looking at his certificate i was wondering why 60a max demand...

but could i legally put 60 amps down, or would i be expected by an assessor to hold back the certificate till the max demand is reduced in some way??

kev.. that wouldnt make the pilot go out

has it been serviced in the past year, pilot injector might need cleaning

1 ive seen on a job, the house has just been rewired completely, and the sparky got his registered mate to do the testing and certifying

Hi i am currentley doing my part p on the new installation certificate in Supply Characteristics, there is a box to state the max load demand.... on a consumer unit with a 100a main switch... 4 x 32a mcbs rings 1 x 16a water heater mcb 4 x 6a mcb for lights + smoke det' 40a mcb cooker...

Q..... when u the first lot leaked were u able to slide the olives off the pipe, is so then scrap the happy shopper olives and get some from a merchants!! If not joint ing compound all round the olive has gotta do the trick.