Search results

  1. P

    Anti Vibration fixings

    Hi, We have a shower waste pump located between joists, which is noisy when running, and also leaks. I posted about this on the plumbing board, but now I'm looking for advice on a better way to install it to try to reduce the noise which I think is at least partly caused by vibrations going...
  2. P

    Under Floor shower waste pump problems

    I don't know if re-routing is an option. The wetroom is in the loft at the front of the house. Below is my daughters bedroom. If we went that way, it would need to go to the rear of the house, through a stairwell then the kitchen. The stairs were installed as part of the loft conversion, and are...
  3. P

    Under Floor shower waste pump problems

    Hi, We have a shower waste pump installed beneath our wet room floor which has been leaking. The wet room is part of a loft conversion done by the previous owners and the pump is used to send the water up and over the roof to the waste pipe at the back of the property. Under normal use there...
  4. P

    Replacing Proteous MCB

    Hello all, Hope someone can help. We have just had a new electric shower fitted (replacing an old electric shower). The new shower is 10.8 kW and after a few minutes (3 or 4) it keeps tripping the MCB. The MCB is rated at 32A - should it be more for the new shower ? Also - we have already...
  5. P

    False ceiling advice

    Thanks for the reply, masona, I think I had better try to explain better the set-up I currently have. The total room is approx 4m by 2m. Half of it (2m by 2m) is higher than the rest by about 8 inches. I've screwed 2" by 2" battens round the 4 sides of the area, and between them run 2"...
  6. P

    False ceiling advice

    Hello there. My kitchen has a ceiling with one end higher than the other. I am putting up a false ceiling to level it out and install some downlighters. The area to be covered is approximately 2m by 2m. I have screwed timber battens around the perimeter and then then hung two evenly-spaced...
  7. P

    Replacing single light with Halogen downlighters

    Hello all - this is my first post on this forum - Glad to be here, hope someone can help. I've seen similar posts, but I'm lacking a bit of clarification on whether earthing is required, and whether the existing wiring is up to scratch. We want to replace a single standard light fitting in...
Back
Top