Search results

Hi many years back I used to use wd40 on the pins to oil them up, what is recommended now?

Any opinions on the above radiators or recommend any other brands ? Thanks

Another photo i assume so if not I’m sticking with the oddesey

Another photo

Thank you he explained the fact of bulk ordering the graphics and how it was ex Texecom that started it up and look wise it is the same design as the Texecom offset so as long as it works and he is doing any maintenance on it I’m happy, but will ask about the hold off, all on a hard wired...

Asked my installer about fitting a oddesey graphics and a new battery pack and he suggests fitting an Orisec one in its place free of charge as he is moving more into this brand, looks the same to me. Opinions please

Hi as above I want to move my smartcoms position, so what would be the best way to achieve this without the tamper activating?

Thanks for your reply

I just wondered if I got it wired in cat cable with baluns and tvi cameras so posted here

Won’t know till Friday when he comes out to see the property all he said tvi would be cheaper than hikvision, so will get two prices from him

Hi I have a hikvision system fitted and asked my installer to price a budget system for my daughter and he suggested tvi over hikvision to save money as it’s only two cameras for the door and car , I don’t know what to do, any opinions please

Thanks for the helpful answers I will set up a part arm and omit the living room and keep the dog in there for the time being

Ridgeback cross roughly medium lab size

Hi self install years back and now have a dog do I need the pet model or can I check via wintex what models I have fitted?

Any help on how to proceed with this please ? Sorted went in via wintex and then selected keypad and put the code in and it reported the update so clicked yes and it installed, yet I tried this via the actual keypad and got no notification Thanks for the help

Yes no change tonight

Alarm works fine just lost on what to do now, tried wintex and also logging in and out at the keypad

Updated my firmware yesterday and just checked and it has the following with the timer icon continuously spinning, any help on this please ?

Thanks all I went for the hanging rail today all fixed ready for the units, ever second hole hit mortar which cause problems but got enough screws to overcome that Thanks