Search results

Hi all, I think I might have made a huge error, cos I have put a JG push-fit elbow in a stud wall (is that the same crime as using compressions in a solid wall?) Second issue is that I had planned to used chrome-plated copper tails to the towel rad (copper tails are already in place but...

Greetings my little Sparky-type peeps, 8 x LED lights in ceiling, wired via driver for each LED into JB (2 x LEDs per JB), JBs daisy-chained back to supply. Cables from JBs all good and secure. Fine so far I think.... But what about the skinny cables from the JB to the driver and from...

Good day all, I am in the process of renovating a bathroom, and have to move the shaver socket by around 200mm (to get it firmly into zone 2 since moving the basin). Wiring is no problem, it is already there - I'm just moving the socket up the wall a bit. But... I have noticed that the...

This is probably a daft question, but.... I'm laying 10mm warmup insulation boards on 18mm ply (no sub-floor below the ply). Warmup site says to use flexible adhesive, then screw the insulation boards using washers. I am concerned that if I use a washer the screw/washer will not be flush...

Greetings good Earth-people! I've just bought a Geberit concealed frame/cistern for a wall-hung WC. The flush plate as supplied will project too far so I need to (obviously) make it shallower. The concertina-type plastic box part has minimum and maximum markings, but I'm not sure how to set...