Search results

https://www.screwfix.com/p/tesla-brass-compression-adapting-flexible-tap-connectors-15mm-x-3-8-2-pack/6089r

Here you go Mottie,

The Torbeck is an equilibrium float valve, they work differently compared to the normal piston type valve.

Iron water pipes are very rare in domestic properties in Scotland and by looking at the glint where you have scraped the pipe there's a good chance it could be plated copper like in the pic here.

One of these in the top of the trap with a cutting of waste pipe, do not use a blanking plug there as previously suggested.

The Logic Water Regs courses are only held at centres in Northolt, Luton, Basildon and Sittingbourne that's a fair bit of travelling to the outskirts of London for a course that has no clout in Scotland Madrab, any particular reason for going there?.

A McAlpine 14 deg. pan connector wont be far away and depending on I.D. of cast pipe one of these, other outlet sizes are available.

What you have there is an old lead lined storage cistern.

Easier for you to go up to 600mm wide towel rad, your 500mm rad will have pipe centres of approx 580mm, a 600mm towel warmer will be anything between 550mm and 570mm centres.

Using the existing nuts, You may have to trim them down a little so the brass nut fits over them.

dilalio, Using 100mm square trunking and 40mm wall insulation would be the easiest, quickest and most practical if you ever needed to access the pipe again. https://www.cef.co.uk/catalogue/products/29794-100mm-x-100mm-pvc-maxi-trunking-complete-with-lid-white-3m-length...

Who is "We" and who told you this?, and only out of interest how long have you been dabbling in plumbing jobs Madrab?.

What you are proposing will be fine.

If you have a combi boiler, throttle the hot tap down a bit when filling the bath..

There will be a thermostatic mixing valve (TMV) fitted to prevent scalding on all new builds ( usually behind the bath panel ) so that the temperature of the water delivered to the bath is no more than 48 oC. https://www.pegleryorkshire.co.uk/EN/Technology/thermal-safety

A 1/1/2" circulating pump washer will do you.

A standard unit is usually 595mm deep and oven 550-560mm deep, it can be done with 22mm Geberit Mapress stainless steel pipe to span the oven space, and 2 McAlpine R1M 3/4" Overflow Straights, for connecting back to 3/4" overflow pipe.

First thing to check is the ballcock is not passing, shut the chrome angled service valve at the ballcock at the top of the store and scoop out some water to below the level of the overflow and monitor the water level overnight, if the level stays the same you just need a new washer on the...

You cannot have a 2.5 metre vertical drop on a 40mm waste pipe. as Hugh Jaleak, run 110mm soil pipe up the wall and use a boss pipe to connect the shower,