Search results

Thanks for that Richard, will do, I might look at putting laminate flooring down, don't fancy putting yet another subfloor down, might hit my head on the ceiling. Would laminate be ok in the bathroom?

Hello Big-all, The board I have has a lux finish (I think this is just sanded one side) this is 15mm thick and under that is 25mm of softwood planked flooring. The osb is secured with screws 75mm at every 20 cm and the osb has been sealed with a water based sealer (like whats used on mdf to...

Good to know that Alarm & Alumni, that Geoff Gardiner always like to build things up and then sell them. What are the risco products like.

I use to use Gardiner technology panels and napco detectors, but that was about 5 odd years ago, easy to wire, easy to program etc, but do not know if they are still about, use to be up rochdale way.

Hello to you all, can anyone tell me if its possible to tile on to osb board, I was thinking of using pva aswell to get a good bond. Help much appreciated.

Hello Norcon, have looked at the site you provided a link for (woodwarm stoves) and it all makes sense now, have also looked at a company that provides the injector tee and that makes sense now. the only problem is that the hot water cylinder is sidted about 2 feet from ground where the boiler...

Hello Norcon, Thanks for reply, I will do a diagram of how it is and as mentioned before, I don't think most of the parts on there are not required but have to say there was no mention of a injector t in the manual from the boiler manufactures. Again thanks for your help.

Hello Norcon, it is a 2 pipe layout with hot water cylinder and yes there is also a rad connected before the pump and 3 way valve so if the pump or power fails then the heated water has somewhere to go to dissipate, there is also a auto bypass fitted. The fire is from Natural heating which is a...

Thanks for that commercialman, makes sense now you explained it to me, so I just wire to live on pump through the thermostat terminals as I see it.

The pump is fitted after the cold feed and vent pipe and the heat sink rad, so if the pump fails the hot water has somewhere to to dissipate the heat. there is also a auto bypass fitted.

Hello Thanks for the replys. @ croydon the system has a heat sink (rad) which is befor the pump and mid valve and a auto bypass fitted so if power fail then gravity does the rest and no risk of explosion and is also open vented. the low limit is for when the water being heated falls to 40c or...

Look at qvsdirect.com, they have a few things aswell. Jeff

If you can put the one on the front on the corner of nthe house looking towards the area to be protected then that should give an overall view of the area and I would go with a hardwired one aswell for the side, its hard to say what as I can't see the layout of the scheme but I would put up a...

Hello the pump is wired into the wiring centre where a cylinder stat and room stat is wired in, not that these are any good as they can't shut the boiler down when their temp has been reached but I wired them in anyway. Do I just wire the pump through the contacts on the pipe stats, but I can't...

The dome cameras can be mounted anyway you want as the camera itself can be rotated and tilted inside the the dome housing. as for the camera recording you can add passive infrared detectors or beams to trigger the camera to record or some units (the dvr/multiplexer, dvr stands for digital video...

Hello Lee, look at cpc.co.uk they have some bits, I think they also do a card that attaches to your computer and then you connect up the cameras and record/view on your computer with time and date indication. Also look at maplin electronics they also do cctv.

Hello, Can anyone tell me how to wire in Honeywell L641 low limit and a Honeywell L641 hi limit pipe stat. This is for a solid fuel (wood) stove so want to switch off the pump when fire dies down and then switches on when fire is lit and water is heated. Thanks Jeff