Search results

That's great - thanks for your help! Hope you had a good one!

Sorry I meant foil backed cellotex board, but sounds like I still need the vapour barrier. For doubling up I meant could I either use ,50mm of cellotex and stick another 50mm to it some how making 100mm then the vapour barrier then plasterboard over the top, or use rock wool in the wooden frame...

Thanks for the clarity, do I still need it if the board is foil backed ? I have already got the board as it was left over from when I did my roof, can I double it up, or use a combination of rock wool and then the board ? I currently don't have any vents as the roof joists to straight to brick...

Hi, I want to convert my garage to use it as a study area, It is single brick with flat roof and as such I plan to create a frame out of wood to allow me to install 50mm foil backed cellotex insulation on all external walls whilst leaving a gap between the warm side and cold side & then...

I'm sorry - could you elaborate please ?

So I would shape a piece of lead to bridge the two sections then run the dry system over the top and put the tiles as close to each other as possible ?

Yeah this is what I am leaning to, I can find loads of prefab ones for different joints but not this so may have to be a manual made one - didn't really want to use mortar to bed then all in if I can help it. Will reach out to Marley and see what they say as they also sell the dry system, if...

Hi, I am fitting a dry ridge system as part of a bigger roof tile replacement project & need some advice, this is on a bungalow with Dorma's - my question is this, the ridge on the Dorma's are the same height as the ridge on the main roof so require connecting, currently they are joined as per...

Apologies for the delay - I hit my peak at work and things went a bit crazy, I have only just had time to install this last night, it works perfectly thank you all for your assistance! Now to add it into HA for more fun. Thanks again Demo

The manual is very handy thank you! Going to have a read later.

HI, So if I want to remove existing Clock & Stat I would wire as such Spur Neutral - Wiser Neutral Spur Live - Wiser Live Prog Live - Wiser #1 Prog Input - Wser #3 Stat Live - Stat input This will allow me to remove both the clock & Stat from the boiler & use the wiser system in place of...

It is a worcester 28i rsf combi - I am at work at the moment so can't access the wiring but can do this evening. Can I leave the thermostat connected whilst the wiser is there as well ? I assume from the conversations that the above would be wired to the stat and not the prog as I had initially...

I would like to get rid of both - so I would wire to the Stat rather than the Prog, got it.

Hi, It is a Worcester 281 RSF combi Demo

Hi, I am trying to install a Drayton Wiser kit 1 on my combi boiler & I want to confirm the wiring as it is an old boiler - attached is the wiring diagram for my existing setup with a room thermostat and a mechanical clock & below is what is required for the Drayton, I can take the neutral &...

As in a Inset fire place. I am using the flue liner that is there but with the new fire the gather hood and flue adapter to attach it to the flue liner is around 1.5ft high so needs to go up where the concrete is, hence the reason for needing to remove it. Cheers

Hi, I have just had the old gas fire removed in my house to install a hole in the wall style one. The original hole was filled up with breeze block to make the fire fit, I knocked these out so i could get the right size hole for the new one. After doing this i looked up the chimney as the new...