Search results

  1. Bigmalc0

    Roofing Felt

    Thanks 'Old Salt', I'll do that, Just phoned them, you were right, they said, 'Just put it in the skip'
  2. Bigmalc0

    Roofing Felt

    I'm taking apart an old damp garden shed and putting it in the skip. The Skip company leaflet states "No FELT" The felt is attached to the shed roof, I've tried to remove it but it's stuck really hard Probably from when it was put on using heat. What can I do, put the roof in the skip anyway?
  3. Bigmalc0

    Candy 2012-80 Dishwasher not emptying

    Hello Polarix, Zipper gives this answer to error code 8 (seen in this forum) E8 signals a heating error. It can have more than one cause so start by checking the heater resistance & the wiring to it. The heater terminals are at the lower rear of the machine behind a plastic...
  4. Bigmalc0

    Candy 2012-80 Dishwasher not emptying

    Hi Polarix, The test is in two parts, the first displays any error code, the next runs a test program. Follow instructions as below. Passive Test Turn the M/C off, open the door and close the soap dispenser, Note dishwasher door remains open during this test. Press & hold down P1, while...
  5. Bigmalc0

    Candy 2012-80 Dishwasher not emptying

    Hi Gump, I went for the monthly option, if it breaks down again and it's not fixable, then you get a new M/C. The circuit board is behind the front cover, held on by a few screws, so possible to get a new board from Candy and do it yourself.
  6. Bigmalc0

    Candy 2012-80 Dishwasher not emptying

    Hi All and Zipper, since my last visit I've run many tests, P5 [rinse] just kept running, P4 was the only program to work correctly, heat, wash and empty. The fault laid with the circuit board, this was replaced and it now works as it should. I got Candy to fix it for me. Gump, you...
  7. Bigmalc0

    Candy 2012-80 Dishwasher not emptying

    Thanks again zipper, I'll do that and report back. Have a good week. Malcolm
  8. Bigmalc0

    Candy 2012-80 Dishwasher not emptying

    Well the M/C finished it's cycle, No error code, all water pumped out. Inside the M/C it is hot which suggest the heater is working. Is there any way the problem can ocure when the delay function is used?, ie over night. Thanks so far.
  9. Bigmalc0

    Candy 2012-80 Dishwasher not emptying

    Thanks zipper for a supper fast response, Top Man, I think I made a typing error, I meant to say '8 Flashes' I've just tried it again, it still flashes 8 times, the other thing I meant to say was 'The M/C is run over night on a delay, [to save electric] on opening the door in the morning, ...
  10. Bigmalc0

    Candy 2012-80 Dishwasher not emptying

    I have a problem with my Candy CDI2012-80 dishwasher, we normally use program P3, the cycle fishes and the dishes are washed ok but water remains in the bottom. Zipper is very knowledgeable and I have followed his instructions to produce the error code, P1+P2 flash 6 times and repeats. I...
Back
Top