Search results

  1. S

    Did the water company remove the interceptor.. trap or not? ..Will it matter? ...Pics

    You were right. The came out and jetted it. It's now always clear.
  2. S

    Should screws pierce the wall plugs?

    They are best short enough that the whole length of them have the full width of the screw inside them (with the pointy bit out the end). The best place for a felling wedge, for lifting purps is beaten all the way in.
  3. S

    How low can the durgo go? What could go wrong?

    Update... I noticed a terrible smell coming in the lean to shelter. The AAV sat atop the soil pipe and was a couple inches below the polycarbonate lean-to roof-The one I had planned to cut through to extend the soil pipe up to the proper height,...until Durgo ideas, at least. I took apart the...
  4. S

    How do I cut a plastic box without shattering the plastic?

    Depending on finish required, for the edges and the speed of delivery, I would use a multitool with grout remover (diamonds) or stitch drill with Dremel and 'pop -pop-pop' connect the dots cutting little by little with Stanley knife. Melting-stinky and horrible. Angle grinder hard to stop it...
  5. S

    Drain problems/rats with no consistent advice

    It would seem that the air intake through your stack is the cause if I understand the following is true..? You get traps/u-bends in the house being sucked/gurgling. It smells in the same place, at the same time. I.e., In the moment this happens, due to your stack not supplying the system with...
  6. S

    Did the water company remove the interceptor.. trap or not? ..Will it matter? ...Pics

    Quickie: Looking at the before and after pics; does this look like the interceptor has been removed leaving a straight run through? ....If it was straight run through, would there be constant standing water? On flushing and observing, you see a 'replacement' cycle happening where only some gets...
  7. S

    Panasonic Bread Maker

    This! Just bought a new capacitor and installed it. I have done the same on a juicer before but wasn't convinced it was the capacitor as it behaved differently to the juicers failure mode. Juicer stopped entirely. Bread maker would growl and stop mixing, sounding like it was straining. The...
  8. S

    Unrealistic wish list for driveway cameras?

    Thanks. Am looking up PoE....
  9. S

    Unrealistic wish list for driveway cameras?

    A brief search of offerings online at likes of Amazon or Screwfix make me think my desired spec is missing something obvious as I can't find an obvious purchase. I would like: -Outdoor cameras, mains powered- I can route power cables to them easily. -Sending data over wi-fi - To a central...
  10. S

    Cracks in walls.... Should we be concerned??

    My 2 p....Yes. Concerned enough for due diligence to be done. Get it properly assessed. You may find neighbours in nearby houses have similar failure modes playing out. Not a time for fingers crossed approach. Imo .
  11. S

    How low can the durgo go? What could go wrong?

    It is still working just fine.Btw.
  12. S

    4 concrete slabs. 25 years old. Tile straight over joins??

    Thanks. Had a feeling it might be a 'no no'. Is there a board or system of boarding that I moderately skilled diyer could install with some kind of substrate/bonding? Obviously the joins would not overlay the slab joins, but would they not then become the site of cracks?
  13. S

    4 concrete slabs. 25 years old. Tile straight over joins??

    We have a utility area. Concrete slab poured in 4 sections. Two small rooms (larder and WC) with boundary at threshold onto the hallway section which itself is 2 strips about 2 m X 0.6 m. Given shonky build of the whole thing I strongly suspect there's no dpc nor bar in the slabs. Was about to...
  14. S

    Wood burning stove -hearth fitting issue

    Which one are you thinking of? Trades have a tendency to use generic terms for sealants.
  15. S

    Wood burning stove -hearth fitting issue

    Lapsed HETAS. The fire cement doesn't like the kind of movement your description creates as far as I am imagining it. However absent the flue being blocked, the Co doesn't 'try' nor usually succeed to get out of tiny little gaps. Like electricity in a weird way it has a preferred route, the...
  16. S

    Should 3 pole isolation switch be marked at all?

    None of that is useful. Well done. There is a while thread on this of mine from years ago, about the mysteries of my wife and the 3 pole isolator. Fill your boots. I only wanted to know about the markings. 333rocky333. Wins.
  17. S

    Should 3 pole isolation switch be marked at all?

    Thanks. Your answer......is an answer! I will have another look at it. I have nevertheless bought a new one which not only is marked but also has a key to lock off the switch.
  18. S

    Should 3 pole isolation switch be marked at all?

    Sparky fitted one above bathroom doorway. Wife couldn't reach so replaced it with pull cord version. Now wanting to reuse the old switch for same job on another WC fan. But noticed it has no markings at all on the outer face. Not a red patch, or on/ off. Why is that?
  19. S

    Fan into WC. Vent(s?) into larder. High/low position?

    I have a small WC and larder as part of a shonky lean-to inherited extension. In larder is washing machine. Not ideal I know...larder is a bit moist! Both doors are ledge and brace with big gaps at bottom. With kitchen door and back door shut you can think of the WC and larder as sealed off, but...
  20. S

    Angle grinder wood chain saw blades

    Very much want one. Want to have a go. And don't, at the same time.
Back
Top