Search results

Thanks- I subsequently found that, and I think that is the handle I need. So should be a straight swap but yes the handle is a bit stiff so I will have a go at adjusting. Thanks!

Hi the handle on my bifold door has just sheered off. Assume I can just replace the mechanism? Any advice on how to remove - I assume the small square panels have screws behind so how do I get access? Photo included

Thanks Ian - I took the actuator off and had a look, the gear looks a bit worn. Synchron motor has one screw, I positioned that correctly (comparing to another actuator). I moved the valve on the pipework and that seems to move freely but when I turned the CH (and the removed actuator moved up...

Sorry- you are correct it’s the lever

Thanks Johny - I subsequently think its a valve issue (new post created). These are bog standard radiators :)

Hi so following an issue with the bottom of radiators being hot but about 90% of the rest of each radiator being cold, I checked the Honeywell valve V4043H1056. The actuator on the side was loose when the central heating is off, unlike another one that is present. I took the synchron motor out...

Hi- I've had a new heating system installed (ASHP and some replacement radiators). Two of the radiators nearest the ASHP get hot. However the remaining radiators around the house only get hot at the bottom, say about a tenth of the height of the radiator, then cold above that. I've reduced...

Thanks John

Thanks - it looks like a solid piece of wood but I’ll do this anyway

Hi - I (the missus) bought a sink and vanity unit where we need to drill the hole for the sink basin waste in the vanity unit. The basin waste seems to measure 40mm but I think the thread is very slight larger diameter. I have drilled a 40mm hole in a piece of ply and I cannot fit the waste...