Search results

Hi Icarus180, I've sent you a PM so you can let me know your email then I'll send you the manual. I've not actually got round to sorting/resetting my alarm yet! I bought a new battery a while ago but just haven't really had the time to go through the factory reset/setup process. I put all the...

Hi, If you let me know your email address I can send you the engineers manual for the Citadel XR2.

Ok got RGI coming tomorrow to have a look. I noticed last night that it's continuing to spark once the flame has lit which I presume is causing the flame to then shut off a few seconds later (not sensing the flame correctly). After the usual 10 or so cycles of on/off, on/off etc, the flame...

Ah, guess my electronic skills aren't too hot! Perhaps the electrical buzzing noises are coming from a different nearby component on the board, they do definitely sound to be coming from the ignition pcb though. Couldn't see too much wrong with the solder joints underneath the board but...

Well it doesn't seem to be a sticky gas meter governor. I fired up all the rings on the gas hob and they lit no problem and at full flame. Had a look at the ignition PCB last night. I think the (fairly loud) electrical buzz noise that I mentioned previously is coming from a relay? on the...

Not sure how much help I'm going to get here but here goes anyway. I bought a property a year ago which has a Citadel XR2 system fitted with just 2 PIR's fitted downstairs (lounge & kitchen [they are the only 2 rooms downstairs BTW]) and a magnetic type sensor on the front door. Keypad...

Anybody have any ideas? I'm now wondering if it could be a PCB fault?

Well, still haven't got this issue sorted but I'm trying to diagnose and I'm tending to think it could be the modulating gas valve causing the problem. Turned it on for CH yesterday after it had been off for 3 days and, as before, it fired up, then a few seconds later went off (pump & fan...

I have an M90E.24S which seems to have developed an odd issue. I only use the boiler every few days as it's in a house I'm renovating so I'm not there all the time. When I do come to use it, it's generally been switched off for a couple of days since the previous visit. I switch it on for...

Perhaps a daft question but here goes, Replacing my bathroom suite and retiling. I've got all the old tiles off and the bath out. Walls are standard plasterboard and skim with the exception of the are below the bath line which is bare plasterboard which has a few dodgy black areas where water...

I'm after a flat thin white PVC strip to finish the inside bottom of my front door. I can't seem to find any that are wide enough to cover the gap and still have enough overlap to be stuck to the bottom of the door. Basically I'm after something like this - http://www.wickes.co.uk/invt/188234...

Ok the boiler now seems to be firing up as it should (although can be a little slow sometimes taking almost 30secs from turning on to flame) but I have another issue now in that when the c.h. is on and running, if I turn on a hot tap the boiler will click (sounds as if it recognises the request...

Thanks, likely I'll be getting an engineer in, just wondering if there were any checks I could do to give me some clues as to the cause of the problem?

I've got a Biasi 24S, probably about 8 years old which isn't igniting properly. Seems to go through all the right motions when powered on - pump starts, fan on (I think, need to double check), and then it tries to ignite (you can hear something clicking away for a few seconds) but no ignition...