Search results

I have just been to install a stoves 550 mini and the gas does not shut off to the burners when you put the lid down. I'm wondering that if it has a cast Iron lid does it require one. I thought that every hob with a lid has to have a cooker lid shut off device. I have disconnected it as If an...

sorry I meant flow rate rather than static pressure..

Its worth a try.. Its more than likely a faulty mixer. But you also have to eliminate the probability of an air lock.

cover the hole on the mixer bar where the shower normally connects to with your hand. Turn the shower on half way between hot and cold. The water from the cold mains will push any air locks out the way in the hot pipework. Don't do it for too long as your header tank will overflow. Caution you...

If your connections reduce down to a smaller pipe bore at the sink taps. This will reduce the pressure.. Any service valves should be 15mm full bore on gravity systems.

yeah, your just eliminating the possibility of an air lock.. let me know how you get on?

just turn one off. either valve.. it doesn't matter

no

O yeah... :oops:

no just one valve will be fine..

try back filling the hot using the cold pressure, there might be an air lock.

yeah.. 3x 2 ports job done..

Make your 22mm connection before the mid position valve but after the bypass. You will only need one two port valve. It will work.. you don't have to have a bypass when you have got a mid position valve. But you have to have one if its an s-plan as when the 2 port valves close completely when...

There maybe an air lock...Turn off all the other radiators and just leave the towel rail on.. If this doesn't work then it must be the valves.

How much higher than the shower Head is the cold water storage tank that feeds the hot water cylinder? Does any hot water come out when you hold the shower head as low as it will stretch? Take the shower head off put your hand over the pipe and turn the mixer to the middle to force cold...

It only has to be open slightly. If you open it to much your radiators might not get as hot. let me know how you get on?

It sounds to me like poor circulation. The heat is obviously leaving the boiler but not quick enough and that is why it goes off after 30 seconds then cools then comes back on. Check the flow and return valves are fully open underneath the boiler.. Then unless your Gas safe registered that's...

Make sure you turn the heating off when switching radiators as with all radiator switched off at once the boiler will over heat..