Search results

Thanks again for all the advice. I'll try those suggestions when I have daylight again. Will feedback on the outcome.

No. I left it as is. Do I need to swap red and yellow so that L2 is red and Com is yellow.

I've tried all those steps and still no progress. I installed a new intermediate switch on the landing (same wiring pattern) and the issue remained. Now both switches have been replaced. I tried the blue and black into L1 and issue remained. I tried swapping red and black over and had no...

So I'd follow the same layout as the attached switch?

Thanks again. Before I try those.2 options I thought I'd mention that I also bought a replacement intermediate switch (pic attached). It doesn't follow the L1, L2, L3, L4 layout of the current intermediate so I can't follow the same cable connections. Can it be used?

If I'm reading the diagram correctly, are you saying blue and black both into L1 and leave L3 empty?

Thanks for the replies so far. I've entered feedback on the table supplied by Sunray.

No, just the 2 switches.

2 switches. The intermediate and a single 2 way switch in the ground floor.

The wiring on the intermediate hasn't been touched (apart from tightening screws). The 2 way system has worked fine for over 10 years.

Bear with me... I have a light on my landing which is operated by an intermediate 2 way switch (on the landing) and a 2 way dimmer on the ground floor. Pics attached. All has worked fine for over 10 years. Recently the bulb started to flicker when switched on then died. I've tried new bulbs...

Thanks for the feedbak Nige. Just got off the phone with BC who say they would have no interest in any complaint my neighbour may have based on what I have told them. The wall is within my bounday by a few inches and nothing overhangs into the adjacent property. They reckon that what my...

I wonder if someone can offer advice on this one... I recently had a standard 3m x 6m single storey rear kitchen extension built. BC were involved at every stage and have now signed it off. My neighbour was unhappy with the finish of the side wall (overlooking their garden) as it was not...

Like the last post I opted to use a varnish. I used Ronseal Diamond Hard Floor Varnish on our oak floor three years ago and it has stood up well. I was going to use the same product for the worktop and found that Ronseal now market it as Ronseal Diamond Hard Varnish. I went for a clear satin...