Search results

interconnect between the two alarms that is NOT live and neutral

Brown will be your live Blue your neutral and orange the interconnect between the two. Normally fed off of the lighting circuit but should ideally be on their own circuit.

If tested properly the values should be roughly the same all the way round .05 ohms variation I think is allowed. The only increases you should see are those from a spur which will be slightly higher

If a ring the values should not increase towards the mid point

sorry texecom is the bell box with integrated strobe.

Scantronic 9448+ or ade optima are both a doddle to wire and have plenty of features for what your after. Such as panic alarm, chime extra internal sounder etc. Any good wholesaler will stock them and I recommend a texecom oddessy 1 or 3 to go with whichever panel you decide upon...

How much do they pay?

---...---

My b+q certainly don't have trained electricians working for them. Was in their the other day on electrical isle. Someone asking what cable they needed to member of staff working on that section, he advised them they needed 4mm and this was for a 10.5Kw shower. You do the maths. I however...

between

ejaculating

of

2 world wars and 1 world cup :lol:

Fair point misread. As for B6 Lighting usually or ch alarm etc

Main switch fuse B6? Bit small aint it.

Yeah agree with the last post, bs 3036's have their uses! Iv'e started to open the board and disconnect the live from the mcb tape end then close panel, just in case someone does turn back on, half the dip dops houses we have to work in can't read or can't be bothered to read if you leave a...

To be honest Carloss if you are fully qualified then I would say you should be earning at least £9 per hour

Yeah, a few months ago working in a council house. Tenant had tried to swap all switches for brass ones, messed it up in a major way and they ended up taking all face plates off an leaving it with protuded wires. My job being a coucil spark was to sort it out, went their and first thing I...

Had a problem similar to this a while ago. Found the neutral bar in the consumer unit to be burning up due to a bad connection.

40A plug in mcb to 63A 30Ma rcd enclosure to 45A pull switch to new shower. All wiring in 10mm Twin and Earth. ok for 8.5Kw shower. Also supp bonding to pipes of shower if in copper.