Search results

Thank you - did as you suggested and works perfectly! thank you

Good point!! However will it not matter if they are in the wrong terminals? Here is a better photo of the existing switch terminals https://imgur.com/a/4DvV1

Thanks all for the replies, the new switch is just a nicer switch. The new switch only has two terminals, L1 and L. Do you know that or educated guess? Thank you!

I want to replace an existing 1 gang light switch. The existing switch has two wires combined into M and one wire into L1. The new has L1 and L - which do I put from the old into the new. Left = old / Right = new Thank you so much for the help!

Brilliant thank you! It's asks the question when setting up the controller app, not sure why.

Hi guys, Setting up the controller for electric under floor heating. The controller is asking: "Select the approximate load of the heating element (w) to estimate installation power consumption (kWh)." I asked the electrician who installed it and he said "It is 150W per m2 - you have 2 m2...

Hopefully as so recent they still stock them. They are large 60' tiles - do you think his offer is fair then? When he lifts the two tiles should he be able to easily see the issue? Cheers!

Thanks for the quick reply. Have to buy a box of tiles. Only think his fault as all new and all his labour or can this 'just happen'? Thanks,

I need some advice please. Had a new kitchen built and floor tiled with underfloor heating installed. This was end of July Floor has just started to crack on two different sides, only hair line cracks but across the middle of 2 tiles. Builder has said he will lift the tiles to examine to see...

Hello, We have bought a project house we are going to modernise. Below is the list of what we plan on doing, just wondering if anyone thinks the order could or should be improved. Many thanks, New windows New front door New consumer unit New plugs/move switches Knock down lean...

Thanks for your help, will give it a go.

Cheers, will go for the copper solution as very little space under basin to get old tails out and new in or to take taps off again. Stupid question but with the copper solution I assume the olive will make it water tight so no need to solder? Thanks!

I am trying to fit a new mono block tap to existing valve. Problem I have is the flexi tales fitting does not fit the valve and the nut that came with doesn't help. I know I need to either buy new flexi tales with correct fitting or a new thing to join the existing valve and tale - does...

Brilliant thanks, has anyone ever used one of these? http://www.ebay.co.uk/itm/MonoBloc-Tap-Fixing-Kit-One-Two-Hole-Bracket-Bolt-1-2-/290938269498 I assume can fit it to any tap?

Hello, Firstly apologies if this is very basic, never done any DIY with taps/plumbing before... The taps on my bathroom sink have became very loose. Upon inspection the nut under the sink has came off and the washer below the tap and above the sink has broken too. Can I buy a new washer...

Hello, I was wondering if someone could help advise me on a damp issue.. The property is an upstairs purpose built maisonette. The stairs are inside the property and are concrete. The inside walls in this area are plaster and painted, the outside wall is pebble dashed. Originally...