Search results

Hello, would appreciate some guidance please .... Replacing a dead bathroom surface mounted ceiling light and hit a snag ... 3 T&Es wired into terminal blocks in the old light (in, out and spur?), plus the switch loop. A lot of wiring to squeeze into the fixture. The ceiling is concrete and...

I will shortly start tearing out the oldstone tiled kitchen floor to replace with engineered oak like the rest of the flat. A little exploration shows the tiles were laid on ditra over a ply subfloor. It looks like the ditra was bonded to the ply with thinset, and everything I've read says it's...

I'm shifting an existing doorway by about 15cm, which is framed by concrete blocks - full photo attached. The engineering is all approved - lintel end bearing still good and all. But I'm not sure how to best cut the block in place without making a huge mess. These blocks are dense and much...