Search results

  1. A

    Extending garage using permitted development

    Thanks for the suggestions cjard. I can't extend backwards as I have my outdoor 'man gym' there. Going to stick with planning and go with the extension to the front which will end up 3m high so plenty of space inside.
  2. A

    Extending garage using permitted development

    My garage is the one with the white door. I went to see planning and as you say it could be done under PD but subject to 2.5m high. I decided this would look daft if I have to have a flat roof at the front of my garage. I've decided to get planning permission and build it with the extra height...
  3. A

    Extending garage using permitted development

    Damn! Thanks for your replies though.
  4. A

    Extending garage using permitted development

    No, that my neighbours house. Mine is to the left just behind the tree. My basic 'paint' drawing shows the house in red, garden in green and the garage in orange. I can access the garage from the bottom of my garden. My house is by the red arrow. It's annoying as the garage is already over 2.5m...
  5. A

    Extending garage using permitted development

    The house is 64 years old. Next doors garage has been extended but some time ago. I believe the garage was built at the same time as the house. This is at the back of my house. The garage is shown on the land registry if that makes a difference.
  6. A

    Extending garage using permitted development

    It is facing the road. That's a pain then. Thanks for your reply.
  7. A

    Extending garage using permitted development

    Hello, newbie here I want to extend my garage by 4m so it's level with next doors garage. I was hoping to avoid planning permission by using permitted development but my garage is already 2.7m high which is above the 2.5m permitted height, if built on a boundary. My garage has been there for 53...
  8. A

    Texecom Premier Keypad problem

    Thank you for the quick reply. That done the trick. Cheers Justin
  9. A

    Texecom Premier Keypad problem

    Hi All I'm a newbie here. When I Part arm my Texecom 48 the panel flashes with the part arm banner. After 20 or so seconds the banner disappears along with the armed led on the panel. The panel has nothing to indicated it's armed. When I trigger a part-armed zone the alarm goes off...
Back
Top