Search results

Hello Yup, as usual youre right. Works like a charm

Hello Having another problem now, bare with me. Cant seem to get the entry zone the way I like it. Want it simple, 1 keypad for set / unset, 1 Pir to trigger, 30 sec delay on entry and exit. The exit works fine, set as a 02 Exit with 30 sec delay. Entry though, no entry time given, PIR...

Hello Got it, as said above; *46705008999 Thanks a lot!

Hello You where absolutely right, It hard writes in the wrong SMSC number in (from the PCB/GSM sender), My phone is to stupid so it only sees what was in there before so I cannot see what the flex writes in. But it also means I got it wrong in the central... which is good new I guess. Now...

Odd, Did not get it to work in the end, took out the sim and it wont text at all anymore (with a mobile). Took it back to the shop, could not figure out what had happened either. So they replaced it. Got back worked fine in a mobile, put it in, tried... No go again. Took it out and ...

...ah you are clever. How you find those for sweden... You dont need the +46, right? I dont think I ever came across that (+) other than under discriptions. Ok, thanks once more, will try tomorrow when i am at the set-up.

hello No, no message center no. programmed. Is it required? I just want to get a text on events and possibly set and unset in the future. I thought it could send text only without pstn / service, gsm module only...

Hello Another Galaxy Flex question, have the GSM module, only want it to text me events but I cant seem to get it to work. Have a working sim card in then; 56.5.17, added the number. Used 56.5.8 and tested, no text, even tried trigger the alarm but it won't send anything. Do I need...

Hello A line between T and 0+ was needed. A typical RTF problem, thanks.

Hello Thanks for the help, current set-up All zones 1001A1 PIR (seems fine 1047 ohm closed, 2036 when open) 1002A1-1018A1 Resistor + set to Spare (all shows 1000+ ohms) problem is the 0001A1 control unit gives a tamper Aux error. it does not show up under command 21, I suspect...

Hello New to the forum, was thinking if we have any Galaxy experts out there. Have a flex20 diy project at home, got the PIRs wired and all and was into programing when I wanted to test. So when trying to exit Engineering mode I get the 0001A1 control unit tamper alarm, and cannot exit...