Search results

  1. S

    Pyronix Enforcer Keypad Menu (display blank)

    Absolutely spot on. The back light is on with no writing or digits, once D is pressed and held for 5 seconds 'Enter Security Code' which I entered 2000 and just like magic 'Address (01)' pops up and changed to (00) and were back up and running!! Thank so much!
  2. S

    Pyronix Enforcer Keypad Menu (display blank)

    Exploring my Enforcer I came across the Key Pad Menu.. The menu goes like this: Language Zone Status Keyclick Vol Master Vol Tag ID Factory Reset(----) Backlight Force PA/Fire Timer Address (00) I was trying to factory reset the system so I could set this up from scratch. I entered the...
  3. S

    Bosch washer/dryer not stopping after cycle ends

    Check out the spare parts on http://www.bosch-home.co.uk/store/spareparts/search Just search by E-Nr (Model) Number and you can view exploded diagrams and part number.. just becarefull you dont select the PCB housing instead of the PCB as you will only receive a plastic casing!
  4. S

    Bosch washer/dryer not stopping after cycle ends

    Sounds like a PCB fault but beware Bosch PCB's are not cheap, also they need to be programmed to the correct model by a combination of option buttons and knob selections, this is not an easy job and most PCBs can only be programmed once.. Just check your appliance is draining ok and also...
  5. S

    bosch wft 2806gb-13 washer dryer drum not turning via motor

    check motor brushes.. you tube bosch motor brushes for guidence, good luck trying to get new ones in.. fiddly! Pull the plug before accessing the appliance...
  6. S

    Aqualtis AQM8F49 Beeping

    Firstly pull the plug out of the socket.... then open your door assy, on the rear of the door will be an access panel piece of plastic which is screwed with 5 or 6 small Torx screws, remove those, flick the plastic cover off and there is your control panel.. The whole lot is pushed and...
  7. S

    Worcester Bosch 280 rsf Overheat thermostat By-passed??

    By the looks of the really bad crimped spades on the by pass wire I think you may be correct there!
  8. S

    Worcester Bosch 280 rsf Overheat thermostat By-passed??

    It certainly does not look like a new one so it may pay to replace.. Do I need a gas safe engineer to fit this then? I pressure it does into the combustion unit? Oh and Ive sorted the heating bein on all the time, looks like a sticky relay on the integrated timer unit, few taps and its...
  9. S

    Worcester Bosch 280 rsf Overheat thermostat By-passed??

    System you mean by pipework and radiator flow??
  10. S

    Worcester Bosch 280 rsf Overheat thermostat By-passed??

    So whats the next steps if it goes open circuit again? Im a white goods engineer by trade but obviously never touched boilers so have no experience on what can cause what. I can assure you I will not bypass the overheating thermostat, like you said Its a safety device..
  11. S

    Worcester Bosch 280 rsf Overheat thermostat By-passed??

    We brought the house and 3 months ago and the room stat went, old danfoss manual stat, so i replaced with a drayton rst1 electronic room stat and the heating will not shut off from its integrated timer.. also the hot water is only luke warm.. and the upstairs rads only get warm altho downstairs...
  12. S

    Worcester Bosch 280 rsf Overheat thermostat By-passed??

    I have just pushed it down, there was no click, it was a smooth slide down when pressing the button, I now have around 3ohms present..
  13. S

    Worcester Bosch 280 rsf Overheat thermostat By-passed??

    Yes it is open circuit, doing abit of research on why there maybe issues with the Overheating Stat (which is currently by-passed) and with this boiler it shows signs that the water to water heat exchanger maybe scaled up? My hot water is luke warm and not hot at all, runs around 20 degrees cent...
  14. S

    Worcester Bosch 280 rsf Overheat thermostat By-passed??

    Just tested and there is no resistence through the Overheat Thermostat.. Looks like it was a quick fix bodge by an engineer??
  15. S

    Worcester Bosch 280 rsf Overheat thermostat By-passed??

    Hi all, previously posted about my room stat which is still an issue but taking a closer look at the wiring diagrams my overheat thermostat has been by passed, is this leagal? obviously this is a safety issue and should of been picked up when serviced?? I still cannot get my timer unit to...
  16. S

    Aqualtis AQM8F49 Beeping

    Hi, I work for Hotpoint im not aware of any machines which beep to indicate faults, normally a sequence of flashing lights or error codes will appear.. If its washing ok and completing cycles then it stands the appliance has no fault altho your control panel may need replacing, but just check...
  17. S

    Worcester 280rsf room thermostat issue

    Hi all, recently moved house to find the room thermostat not operating at correct temperate, it was on old Danfoss room stat. I replaced it with a Drayton RTS1. Now my timer/programmer which is intergrated into my Worcester 280rsf is not switching the heating off, It is programmed correctly...
Back
Top