Search results

  1. A

    Light Remote switch not working

    That would be good as I connect my remote to alexa anyway. For 3 way something like this would be good? https://amzn.eu/d/4aEdur8 The control switch is concealed between ceiling & chandelier so I need something I don't need access to once installed.
  2. A

    Light Remote switch not working

    Hi Subject can be better so advice. I have chandelier which is connected to 4 way remote. The issue is that everytime i switch off the mains and when turning back on the chandelier stops working. I then have to go through a tedious task of removing it completely from ceiling and changing the...
  3. A

    Boiler turning off after startup. Need a new PCB?

    Thanks for that. Confident enough I can change pcb. Just not sure of it's the right course of action for the issue. Might try changing pcb, and if fault continues will get an engineer. Thanks.
  4. A

    Boiler turning off after startup. Need a new PCB?

    Boiler turns on with display and then turns off. I think it turns off as soon as pump turns on, not sure. Diverter valve was replaced 6-8 months ago. There has been couple of F70 error before and after the diverter replacement. What could be at fault? Likely cause is a PCB? Here is youtube link...
  5. A

    Flush (not powerflush/drain) CH system

    Hi I want to flush CH system after adding x400 and leaving it for a 3-4 weeks. I'm planning to open drain valve while opening the mains water into CH system, hence flushing (not draining), one rad at a time. Correct me if I'm wrong. My challenge is that automatic bypass valve will not allow...
  6. Abv

    Abv

  7. Boiler flow with abv

    Boiler flow with abv

  8. A

    A

  9. A

    MagnaClean on flow

    Hi I'm planning to add MC5+ cleaner to the system as there is a lot of sludge & rust. My concern is that since magnaclean is fitted to flow, the boiler may end up with debris and create problems. I'm planning to drain the system in a week's time and at that point will change the pipework...
  10. A

    Vaillant VCW 18 Sine Combi Bolier, stopped firing up.

    My Vaillant vcw-sine T3 stopped firing yesterday. Reading the posts on the forum I switched off the pilot light using the red button. However, unable to light it up now by pressing green button and turning the spark generator. Any advice is much appreciated. I see a lot of owners for this...
Back
Top