Search results

I recently had my 2nd bedroom skimmed and there's a patch underneath an air vent/brick that doesn't seem to be drying out. its been 3 weeks. The patch is probably 2' wide by 1' tall about 7inch below the vent. I took the air vent cover off and removed wooden boxing and found the 2 courses of...

I recently had my 2nd bedroom skimmed and there's a patch underneath an air vent/brick that doesn't seem to be drying out. its been 3 weeks. The patch is probably 2' wide by 1' tall about 7inch below the vent. I took the air vent cover off and removed wooden boxing and found the 2 courses of...

I isolated the boiler and pressurised to 2 bar and left off overnight. The pressure dropped to 1.75, only the tiniest spot of water from condensate pipe. When I reopened the valves the pressure dropped immediately to 0 Not sure what this means?

pretty sure theres a plastic u bend with a cap that I removed and its dripping through the there. The other end of that u bend goes to plastic piping that goes outside. Theres also a copper pipe that goes out side and I think that's the prv one.

thanks I will, after leaving the boiler a little longer the drips have virtually stopped less than 1 a minute. Its when its running that it goes crazy

ITs dripping whilst the boiler is off but at a much slower rate. Can the heat exchange be repaired? Or is it just a replace it with a new one? Theyre not cheap :(

Hi my Worcester bosch 28i boiler is losing pressure from 1 bar to 0 in less than a day while running. The condensate pipe drips at a very fast rate whilst its running, I know its supposed to drip but any faster and it would be a stream im sure. Heard from other forums that it could be a...

edit

edit

The water is leaking through the condensation pipe, a considerable amount, i think this is the problem. Nothing through the pressure release. Anyone know what the problem is or how to fix? Some other things have mentioned leaking through the heat exchange?

worcester bosch 28i

Hi my boiler has been losing pressure. I read on the forums it could be the expansions vessel so i bled my radiators (only the tiniest bit of air) raised the boiler pressure from 0 to 0.5bar then pressurised the expansion vessel to roughly 0.8bar (on the foot pump gauge) . I then took the...

Thanks for your reply RF lightling id almost lost hope with this forum, Flourescent tubes lol, that'll look good, ill look into those bulbs Thanks

What i think isnt really relevant the info is there, if anybody could shed some light on it.

Hi Im planning to install some spotlights in my kitchen. its dimensions are 2.1 x 3m. Im using 250 lumen cool white GU10 4w lamps. (240v LED) Im planning to space them in 2 rows of 4. with a 1m space between them 0.5m from the wall. ( if that makes sense) The ceiling height is 2.6m Is...