Search results

Thank you for your reply. One quick question, what does FCU stand for?

Looking for a bit of help please. My wife switched on the oven and after about 5 minutes she heard the oven making a noise. On opening the door sparks were coming from the fan. It was switched off. Now when I switch it on, the fan doesn't spin and there appears to be no heat from the element...

I have cleaned the contacts with sandpaper as suggested although it was a bit awkward. I decided to remake the connections to the connector block. I cut all 3 wires by about an inch and then fitted them to the connector block. Since doing this i have had no problems with the machine at all...

Ok, I'll try doing that if I get time tomorrow with it being Xmas and all that if not then the day after. Thanks for all your help so far. Have a Merry Christmas.

The connector block that is connected to the wiring loom shows signs of arcing on one of the three terminals within the block. It is quite black whereas the other two look a gold/ bronze colour which I would expect. I can't say for sure which wire it is, there are 2 brown wires and 1 red wire...

Yes the lever on the door is locking into the interlock. It appears to me that during the cycle something within the interlock circuit is dropping out, whether it is the movement of the machine causing it or could it be the supply to the interlock dropping out momentarily causing the machine to...

Yes the filter is clean and there is no water in the drum. When I get it working it drains in under 30 sec. I've been messing about with it today and when I get it working it goes ok sometimes and then it seems to stop, when it stops and I push the door I can get it to start again which...

I have checked the brushes and they appear to be ok. I measured the amount of carbon left and it is just over 2cm (2.2 to be exact)

Thanks for the reply. I will check the brushes although I did replace them in August. Sometimes when I try and run the pump out programme I get the same symptoms which was making me think that it was something mechanical rather than electrical as I assumed that the motor and brushes have...

Hello, New to the forum and looking for some help with a problem i'm having with my washing machine. About 5 weeks ago I started getting a clicking noise from the door interlock and had trouble opening the door and the machine would randomly stop mid way through it's cycle. To open the...