Search results

To be honest I’m not sure. Only reason I can think is the ground level at the back of the house was higher but I’ve dug this right back down to where it should be anyway to stop damp

I’ve got a house built maybe 1900s ish Half the house is suspended timber and the other half is concrete floor with no dpm or insulation under it I’ve done two knock throughs and the floor levels are all over the timber side is nice and level but the concrete floors arnt The concrete floor...

Yes. Lintel already in place Remove window Cut brickwork using 9inch grinder and diamond blade or Stil saw Fit doors

Very unlucky there. Take a few bricks out above the timber and see if the roofs sitting on the chimney or going through the middle to the wall

I’ve got the same problem. I’m going to Remove the plaster so you’ve got the joists. Increase the joist thickness to 150mm then use 100mm insulation board between the joists. Over board then your done

I'm not a builder I'm a leccy hence the probably daft question but I've got a few bits on insulation I'm not sure of loft - , not for a bedroom but its going to have a velux. staircase and carpets etc. its basically a clean room for keeping stuff in, its got 3 sloping sides so not much use for...

Extending the cables will be fine I'd personally blank the existing spur box. Make a joint in it so it's accessible and run it along to the new back box

I can get the fall and access it easy enough. Would an s trap toilet be better then a sweeping 90?

current situation. Toilet is on an outside wall with wast horizontally into the soil pipe I'm planning on moving the toilet to the opposite wall. Which is an internal wall Can I fit 180 degree sweeping flexi and drop it into the floorboard cavity then out into the existing soil pipe...

Earth won't stop it going off. Probably best posting a pic of how you've wired it

Have you tried removing the appliances from the circuit?

If hate to live next door to you

Caravan storage

Visual check of the meter

Hi. I can get a Yale 6400 for £80. I've currently got no alarm and there has been a few break ins in the area. Is this alarm better than nothing or is it worth keeping my money, buying a samari sword and hiding in the bushes ?

I've just moved Into a house with one of these fitted. The alarm box is fearful A fused spur but the fuse has been removed. Also there is no keypad In the house. Is it a lost cause trying to get it up And running. It appears that all of the sensors etc are already wired in which is an advantage

Hi. Thanks for the reply. Yes I've had the pump apart and it's fine. Don't think it's the pump because when I make the switch everything works

I've had the full valve apart it's all clean and free

I've had the flow valve apart and the diafram was perished. Bought a new one. Cleaned the valve out and it's free, put it all back together and it's exactly the same

Thanks. Should I do that whilst the boiler is on and there's demand? Or should I do it when the boilers off? I did has the cap off earlier and span it but only about half a revolution