Search results

Pulsed tone, zone 3 flashing..?

Right done all that.. But just doesnt set.. Goes off and day light just flashes red and siren flying off

Ok so set the timer to longer no difference.. Took out links to zone 3... And now it buzzes/flashes when i try to set the alarm. Im guessing this is a programming issue and some code needs to be entered to omit zone 3 from being set..?

Well the thing is it doesnt show zone 3.. When i set the alarm, it starts to set then sounds off adter 10sec.. But nothing on the zones is actually flashing..?

Bin the alarm? Yikes. Really?

Iv looked in the panel and zone 3 seems to have a red wire looped in and connecting to each end.. Doesnt seem to be going anywhere but back into each other.. So should i just unscrew and remove the red wire? Does that link it out or do i need to do something additional to that?

Yes iv been using the engineers code... But it doesnt seem to recognise the command "15" .. Iv been trying to link out the zone but hasnt worked. do i need to actually disconnect the wires?

Hi i have a scantronic 9488 - 3 zone model alarm i have just had to re-wire the whole electricity in the house and had to reset the alarm. So, i have used the manual and reset the alarm code etc - all fine. However, only 2 zones are active, zone 3 is not wired into anything. the alarm does...

Hi, So we have just moved into a new place which has a Vokera Syntesis Combi Boiler. At first, everything was working fine - got hot water, got hot central heating - all fine. Then I noticed the pressure had dropped into the red zone, so I increased the pressure as you do and brought it...