Search results

  1. R

    Beko Top Spray Arm

    Hi all I have a beko dfn28r31x dishwasher. The top spray arm isn't spinning (although water flowing through) and top rack not getting cleaned properly. I have: * cleaned out filter * new feedpipe (the bit that runs along the bottom of the upper rack) * replaced top spray arm * flushed the...
  2. R

    Lots of cracks!

    1930s extended bungalow. Upstairs is a mixture across the two impacted rooms - mostly bedroom and eaves.
  3. R

    Lots of cracks!

    Another 'cracker' of an example...
  4. Xracks

    Xracks

  5. PXL_20230107_142728042.jpg

    PXL_20230107_142728042.jpg

  6. R

    Lots of cracks!

    We had the bedrooms replastered a while back, maybe 2 years, by different plasterers. Both rooms have pretty significant cracks, some crossing right over ceiling, or down walls. What is the best course of action? Try and fill, or have large or even whole sections reskimmed? And if reskimmed...
  7. Cracks

    Cracks

  8. PXL_20230107_142914121.jpg

    PXL_20230107_142914121.jpg

  9. PXL_20230107_142738297.jpg

    PXL_20230107_142738297.jpg

  10. R

    Closing up vent

    I've done some more reading and I *think* For chimneys removed to below roof line (two of three in my case) these shouldn't be vented in bedroom as hot air running up can condense. For capped chimneys (one of three in my case) these should be vented in room. I may reinstall one, we were...
  11. R

    Closing up vent

    I should add, when I put them in I was definitely winging it. Followed a rough guide I read online and went for it. They poured cold air into the room, I thought maybe they'd allow warm air to go up but was surprised how much cold air they pumped in.
  12. R

    Closing up vent

    Two of the chimneys have been removed, and vents added to the exterior. The other one has been capped and lead works renewed. Do you think I need to do a U-turn and open them back up? Or wait and see...?
  13. R

    Closing up vent

    I've used small bit of foam, then after that dried up I used poly filla waiting on that drying then I'll sand down and paint. Ok bodge job?
  14. Another

    Another

  15. PXL_20230106_160257136.jpg

    PXL_20230106_160257136.jpg

  16. R

    Closing up vent

    Does this work:
  17. Vent

    Vent

  18. Vent

    Vent

  19. PXL_20230104_141716725.jpg

    PXL_20230104_141716725.jpg

  20. PXL_20230104_141823441.MP.jpg

    PXL_20230104_141823441.MP.jpg

Back
Top