Search results

Just an update in case anyone ever had the same and is curious (obviously still worth getting your own professional opinion). We had a structural engineer come view it and said the wall was not load bearing/supporting and we could either leave it or take it down. We have since taken it down...

I wondered that also, but it doesn't make sense, because there's another separate chimney on the left hand side (it goes straight up). And all of the houses on this street appear to have that, so it must be original I assume.

I recently noticed a crack in a wall which is under our chimney stack. I can't tell if this wall is supposed to be supporting the stack or not, but right now it isn't. The wall sits on a wooden lintel which half rests on the brick for the stack and the other half across ceiling joists (I think...

Thanks, I'll contact them to see if they can do anything

I used 6 of these: https://www.amazon.co.uk/Energizer-Ultimate-Lithium-Batteries-Pack/dp/B000IWW1G6 Which I thought would be close to the genuine cell as possible.

Thanks for the reply @ianmcd do you think it's the remote sub assembly then? Basically, an electronic part at fault not the oxypilot?

My parents have a Legend Firestrata gas fire in their living room. They don't use it often and hadn't used it for roughly two years due to the battery dying (it has a IR remote control) and the replacements being expensive. I replaced the batteries for the fire and everything was working...

My parents have this same fire and came across the same issue a few years ago. They bought a replacement battery from a 3rd party company which lasted for a year or so (they're not sure on specifics) and then the fire had been left for a while. When I came to look at the issue again today, I...

I can see where you're coming from, but it's not been an issue for over a year (even when turning on the kitchen tap, the shower wouldn't really greatly effected).

Hi All, I fitted my bathroom about a year and a half ago now. I changed the shower from an electric powered one to being fed from the boiler. It has been fine (good water flow/pressure and always good temps), but for the last few months I have had the issue of reduced pressure, and intermittent...