Search results

i did this "repair " on the boiler in the annex....however notice that as trhe shower is being used more at moment it sometimes runs hot then cold- so should I replace the resistor OR is it just that the boiler will never be able to run consant warm water

Cheers guys , had a 1litre per minute output, and not firimng on DHW only ( so hot water only when Ch also on) having tested water pressure at various points I assumed it was blocked somewhere in heat exchanger- but having found this thread just removed the blue flow resistor, and no all...

Its upstairs ( extension) I don't have reason to worry about flow. but did wonder is given the exit point at wall is below floor level ( will need a U bend join and then up pipe to allow before joining to bath waste ) where to place "trap" but thanks you seem to have answered that

Changing a shower to a bath. Hope to use same exit for waste out of wall, shower waste trap ( horrible- now removed ) was fitted below floor level. ( which will be tiled over) My plughole on bath is at other end to where the existing waste is, so will need to pipe it about 1.2m, and will...

I have purcahsed one - comes with 1. Whirlpool pump ( attached to under bath frame) 2. Steam generator 3kw .. the power from which also provides 12v to power radio / led lights both come with a standard 13amp uk 3pin plug , although the generator does also have an inline rcd type control...

It's 2.7 Kw max, but should be OK as an addition to CH. More of a focal point than a heating solution looking at the same model myself, or that dish / bowl they do- inset in to something similiar. My fire place was also a 70's brick,- pulled it out but the brickwork inside is in a bad...