Search results

I am sorry I placed this yesterday wrongly in building. Would any roofers have a look, thank you.

The notice in loft was placed there by insulation installers.

I have been up on my ladder and looked as closely as I can and the tiles all seem good and in position. Could it be that as suggested it is simply the moss and the fact that a section of felt is dislodged the leak happens. Sorry for my delay of response to all reply's but I have not had any auto...

I live in a semi bungalow late 60s build. Water is dripping down rear small bedroom light fitting, which I have made safe. I cannot see any roof damage on the outside but in the loft above the area where the light fitting is the felt has dropped away, every where else it looks normal. Where the...

Thanks for your reply's, what I am unsure about was the possible movement of the timber due to temperature changes etc of the timber. I am not sure if a firm mechanical fixing was ok. I am to use the supply for a florescent light and a single socket to power hedge cutters.

I hope this question is in the correct section. I am going to run a 1.5mm 3 core flex from my garage to a timber shed in 20mm plastic conduit distance approx 2ft. My query is should I take the conduit into the shed via a 22mm hole or stop conduit at shed outer surface and pass flex through a...

I have removed my old 6ft x 8ft shed of around 25yrs old erected by the house previous owner. It was up-against the rear of my garage on one side and very near to the side of my neighbours garage at its rear, so I intend to replace it with a 5ft x 7 ft one to allow me to get around it. I am now...

Have now cracked it, it was pointed out to me by a Texecom Tech expert to check the area address setting of the keypad. Doing this I discovered that it was only programmed to A adding B solved the problem.

Thank you again sparkymarka for your kind responce. I have doubled checked the settings with the manual all the sounder options are on as in the list, I have followed the flow chart through on page 81 its programmed exp *1,1 areas AB vol is at level 4 The speaker DOES sound if there is an alarm...

To the expander spk o/p

Thanks for replay. I have checked and area B spk is enabled, I have also realised there are no tones also from panel buzzer etc.

I have no exit tones from the indoor speaker when setting area b And how do I change text for part set in area a I have changed the full unset banner ok and the banner for area b set ok Thank you in anticipation

Sorry I am a little confused do you mean log into the app on my smartphone ? Or log into the panel I have looked in the app but cannot seem to find mannager It lists all my codes and screen names.

Sorry for my delay in getting back Just to go back to the beginning when I log into to the app. with either the master or the area A code the results shown are the same only area A results. When I try to use the area B code the app does not let me log in. I have tried to follow the installation...

I believe so

When I am logging in to the app.I use the master code.

Yes using separate codes As regards all area setting I will need to check when I return to home

I have a Smartcom fitted to my Premier Elite 24. It fails to report anything in area B. However with area A it reports every action/event I presume that something may be incorrectly set up.

Its a two area set up, when area B is armed and then area A is armed in part set ( bedtime ) The kp display toggles ever one second from area A set, area B full set, part set A plus the time date. This continues until area A is unset ( nxt morning ) Can this be adjusted in some way.

Thanks for info, I assume if I replace O ring or vent plug with both valves off water escape should be minimal with no loss of system pressure.