Search results

Clockwise to turn off?

On taking of a thin plastic cap there is more plastic and a screw head.

Thanks. Are you referring to the plastic top of the valve when you say 'head'?

I have five small radiators with a valve as shown in the attached image. Are these radiators capable of being switched off? In twenty-three years, the radiators have never been touched, and the valve shown is impossible to turn, if it's meant to turn. Help would be appreciated.

Thanks. It's actually a 2-port valve. HW came on without a problem this morning. There was no need for CH to be on, but I can guarantee that sometime in the next few days, it will not fire up. That's why I was wondering if the valve is actually receiving an electrical signal to fire up on the...

I have a Worcester Bosch system boiler and I'm experiencing an issue where occasionally I can put on HW on its own but more often than not I have to have the CH on as well. Sometimes the HW works for a couple of weeks without the CH on, then suddenly, I can't call for any HW. What I have noticed...

.........but the rat had already been seen in the property before the air brick hole appeared.

We know a rat has been in the house but would they leap 4mts to the ground in order to escape the house?

We know that a rodent has been in the house at ground level but appears to have escaped at first-floor level.

I've attached images of a damaged air brick. The brick is about 3 to 4 mts above ground and a rodent appears to have escaped to ground level outside from underneath floorboards. Plastic can be seen at ground level and a first-floor toilet is not far from the air brick. Has anyone seen a rodent...

I am going to fit a washer or two.

Thanks. It appears that the packing was the issue and the nut now screws on successfully with no leaks.

This was the image I meant to post to your comment.

Thanks. I have got a spare Garden Tap without a check valve. Would it be possible to replace the section of the tap indicated by a red line with the same section from the spare tap.?

I've attached an image of a Garden Tap where the unscrewed nut will not screw back on. I don't know how it became undone (maybe the large handle unscrewed it) and I began to wonder if it was a left-hand thread but no amount of attempts to re-fit works. Could something be preventing forward...

Thanks.

Thanks.

Is it possible to name the make of a kitchen tap shown in the attached image? I need to replace the spout o rings which appear to be 2cm outside diameter but the make of tap would help with confirming o ring size. Thanks

Thanks. Well I know I have got the spline count correct.

Hello. Is there any sort of standard coding for ceramic cartridges? I have the measurements for a 20-spine, 3/4 cartridge but there appear to be various choices with slightly different sizes. I do not know the name of the mixer taps the cartridge belongs to. I have attached an image of the...