Search results

My Ufh has a separate pump but needs both running wether its on together with the rads or stand alone.

Stihl seem to be discontinuing the smaller AP batteries in favour of the 300S and 500S which have bluetooth connectivity that through their app give all sorts of info on runtimes, service data etc, this may be why they are giving away smaller batteries. Previous to this there was a Smart...

Are there some tabs folded over on the top of the holders, if so fold them open, replace the brush and closed again holding the brush spring compressed . A contact soldering iron doesn't normally transfer enough heat to silver solder.

I have silver solder rods which I don't know the MP point of but needs a flame to run it. For delicate work I use a kitchen torch which does the job.

Not sure if solder on in brush wires could melt when motor under a good load, Ive repaired with silver solder which has a much higher melting point just in case

Just dust it over and leave, if its dry weather I just damp it down with a fine water spray

You never know your luck until you try

Bit if a typo there, if you have hydrangeas wood ash as you rightly say turns the soil alkaline but makes blue ones turn pink.

If that's your actual email I'd take it down before you start getting all sorts of rubbish. Also get more response in the gardening section

Biological washing powder has totally wiped out quite heavy infestations of moss in 4 -5 days for us

It was nice to see the male swallow that nests in an outbuilding show up for the first time since departing with his mate and 2 broods last Autumn, it will be a week or so before the female shows , if she's made it.

Pv panels work better the cooler they are, would the roof reflect or hold heat...its worth asking the installer I guess.

Should surface water be directed into a well as it bypasses the natural filtration process as it percolate through the ground into the water table

Or even an expert novice!!

As knowledgeable as some folk on here are I think if I'd paid to have the calcs done Id have ask that of the SE.

Anything here https://www.designingbuildings.co.uk/wiki/Right_of_support

Ive put 100mm slab insulation under bathroom and ensuite floors + in the walls which hasn't made a jot if difference...

Excessive accumulation water can also be a result of a buildup due to an inability to evaporate like the building may have designed to do due to cement products or impervious coatings blocking the way.

You may not have a damp course as the bond on parts suggest solid wall which were probably built using lime mortar. Not suggesting you go down the route I did but interesting reading : https://www.heritage-house.org/damp-and-condensation/managing-damp-in-old-buildings.html

I leave my gun with the can on in the use position, sometimes for 6 months or even longer. There are some who say this is the wrong way up but I have found this the least troublesome way. Edit: I did a vid several years back. https://www.diynot.com/diy/threads/foam-guns.540955/post-4584386