Not yet as I wasn't sure whether to run that or just earth to all the fittings as my plan was to save money by running it myself then leave tails at all the the fittings and consumer unit and paying an electritian to finish
Turns out the sockets are fine but I'm unsure about the light switches as there is only 2 reds no earth same at the light pendants basically I wanted to change the switches to metal ones is this ok? Thanks
Hi
I have 2 red wires at each (lighting) outlet in my house, so was wandering if it would be possible to run ground wires to each outlet and back to the consumer unit. Paying an electrian to connect them as I already have floorboards up etc.. Would that work? Thanks
Hi
I have removed some plaster from a block wall which has left plaster ingrained in the rough blockwork I've gone over it with a wire brush but ain't touching it I won't to dot and dab the wall just need to know if I have to remove what's left of the plaster before I do this and if so best way...
Thanks for the reply what ratio of pva/water for 1st and 2nd coat of pva will be needed?
Read more: https://www.diynot.com/diy/threads/high-suction-background.494465/#ixzz51YPJNCGr
Hello
I'm planning to dot and dab a window reveal but I'm not sure about the underside of the lintel I tried to damp it down before putting the board up but it just keeps drying out I've used a whole spray bottle even brushing on water but it just keeps evaporating within seconds it is about...