Search results

Hi I know this is an old thread but I am in a real bind. I have removed my pump to replac ethe o rings sent to me by Salamanda but after removing the 6 bolts that hold the impeller housing on I still cannot get it off. It feels lik eit is held by something else around the impeller shaft. Has...

Thanks Gasgeezer, If it is an overheating problem what could be the possible cause? The boiler seems to work fine for an hour or so then seems to trip. Resetting fixes it for a while. I do not see any LED sequence other than the reset LED on, there is no flashing.

Hi, I am having aproblem with my Micron 60FF. I have just fired it up again for the first time since the early spring. Now it seems okay water hot rads warm etc. But when we get up in the morning the boiler has not lit and the reset light is on. If I turn it anticlockwise the back to the...

Hi all, I calculated the heat loss for the room which came out at 3186 BTU/Hr. The rad in the room is a double panel 1400 x 600 rated at 8126 BTU so I guess the rad should not need to be swapped.

Thanks for all the advice. I turned the room stat up and the hall rad down a touch and this morning the bedroom was 18 deg :) . Not sure what the gas bill will be though :(

ha ha! now I see..... where do I buy it :lol:

Dry ice :?

Al thanks for the reply. I have TRV's on all rads except the one in the hall. What if I turn the hall rad right down so that it does not switch the roomstat off. My bathroom rad is on a bypass so I can us eth towel rail heater without other rads on.

Hi all just an update on my problem... err! it still hapens occationally. I am now wondering if it is just running short of hot water to get the desired temp so is shutting off. I say this as it seems to happed after the shower has been used for a long period. "wife shaving legs !!" or after...

Hi all, I have detached bungalow with a north facing bedroom which in turn has three insulated outside walls and a 3m wide double glazed bay window. I am having trouble getting the room above 13 deg with it dropping as low as 11 on cold nights. The radiator is a 1400 x 600 double convector. The...

Hi , no pump fitted. Problem has not happened since so it's very intermitant :(

Thanks.. But can you explain what a expansion problem is exacly?

Thanks for the replies. Having checked the header tank after the first shower today I can confirm the header is not running dry. So the shower problem must be due to something else. I think I will take the mixer apart and clean the filters. As for the slow filling header I will check out the...

Hi, I have a Mira Excel thermostatic mixer shower. Recently towards the end of the first shower of the day the shower stops running. After a short while it will run again. I checked the hose etc and all is fine. I then called Mira who said it may be due to partially blocked filters. However...