Search results

Hi Sparkmania, I replace the PIR yesterday (using just my user code), & it looks to have done the trick, thanks for all your help

Thanks for all your help, Sparkymania, I'll check out the PIR today as a start point

Thanks Sparkymarka, using the walk test as you suggested, I have established Zone 2 is the hallway. I guess that means I should open up the sensor & if no obvious reason for failure I should perhaps change the sensor. Is that a straight change out or do I need an engineers code to set it up?

I don't know which sensor is Zone 2 though. If I undo each sensor cover in turn, Zone 2 will become apparant on the control panel I guess. Will just have to hope that the user code will permit reset. Then I suppose replacing the faulty sensor would be appropriate, unless there is something...

Hi, the log says Burg Z02 Alarm when it went off on both instances

Hi AmzWag, I can't really answer that as I was asleep & awoken by the alarm in full shreik mode!

Hi, thanks for posting. Unfortunately at 3am last night I just wanted to turn it off and was too bleary eyed to read the description on the panel. Same happened an hour later at 4am. I would have to wait for it to happen again to answer your very relevant question though and I don't really want...

Hi,I am finding that my i-ON 40 burglar alarm is going off randomly (in the middle of the night of course. I only have the user code & not the engineer code. As the battery is a few years old I thought I'd replace it, and then if that does not fix it I'd check the sensors for insects, etc. Can...