Search results

no1 here to help?

fault cured striped turbo and cleaned it lot of gunk in there also cleand intake manifold problem solved

i replaced the maf still not coured the fault, dammit.going to strip turbo and cleanit out now and also the my inlet manifold of and clean the gunk inside it.is the map sensor a replacable part as its soldered to the ecu board.

av ordered a maf sensor from euro car parts,dam things expensive coz am not sure its that,i hav opened the ecu looked inside it the map sensor is only a little black box type thing soldered to the main ecu board.av tested the maf sensor,volt test should be 1.5volts on idle but shows me 1.55volts...

sorted guys removed door lock and took it to lock smith for key making.all good.

did disconnect maf sensor made it worse turbo wouldnt kick all the time

vnt mechanism moves up and down when reving,also moveit by hand.av put it on a diagnostic machine comes with code 00519 map short to b+.map sensor built in with the ecu box.

turbo kicks in upto 3000rpm but loses power in 3rd gear and over.checked n75 valve n changed vacum pipes,

i have a problem with my passat turbo goes after 3000rpm and only comes after i switch engine off b+ on my vagcom software av tested maf sensor and checked all vacum hose need help any1 out there with same problem solved

got peugeot 406 td fast idle stays around 1000rpm at idle at all times does anyone know what it is,mil light is not on,also isit obd2 complaint.got the socket for it but dont showup on my diagnostic software,can it b the sensor on top of the pump or the vacum hose fuel consumption gone hi too.

tryed that no luck,no spare key.need help big time

freind of mine close the bonnet with the keys in side theres no way of openning the bonnet cause u need a key its the ford new security lock system,please can any one help got any ideas is there anyway we can open the bonnet with no key think it maybe electrical anyway of shorting it out to open...

am going to run the cable on the wall not in the ground i am going to dig the groung for concreating bu t dont wantto run cable in the ground,what size wire do i run from the CU whats rcd where do i fit that can i not run a ring in the shed its a brick shed not wood.i hav a socket near the swith...

i have not done this type of work i am a mechanic by trade but i hav built a shed dont know much bought domestic wiring freind of mine brother is a electrian i have asked him to come round and explain whats the best way to wire up my shed then i wil go from there il let u guys know how i get...

thanks for the reply,am goin to turn the shed into a small workshop maybe run drills small heater things like that,i have a CU with trip fuses i think i have a spare gap i have to double check,can i run a spur from the kithchen to shed and go round, no i dont know bout building regs need to find...

hello,i want to wire my shed with 5 sockets and two tubes running of a twin swicth how do i doit from the CU or? whats the best way. the shed bout 9metres away from the house please help.would be nice if u can show diagrams to.