Search results

That you for your amazing help. I will try different combos, as I think the wiring is right, maybe the colour choice of wired is wrong. Other than getting a ladder to check reach the bell and dismantle, is there anyway to know what wires were used?

I have managed to get rid of zone tampers, and zone opens. My keypad is error light free, and displays date and time, with a 9651 number (not sure what that is). I still have a problem. I’m sorry. So, the external bell. I wired the red and black into the 12 and 0V. Yellow and blue to OP1 and 2...

Hello, I had a relook. I have left the comm a/t where the zones are wired in empty, but I this a tamper loop is supposed to go here. What is a tamper loop practically, is this a wire going from one to the other comm a/t to create a loop?

I have tried to put the cover on with no luck. And can’t see a tamper micro switch. What do you mean ‘short the tamper zones’?

Keypad working, yippee!! Time set. But it won’t let me leave installer mode, as ‘tamper zone 1’ then listing through all zones. Just keep saying this over and over. There wasn’t anywhere to put a tamper for zones, so I don’t understand.

I looked behind the keypad, and it looks black, red, yellow and blue are plugged in, in that order, so I repeated this on the control panel. But no change. I initially had green instead of blue on panel, no difference. Shall I try all the combos?

So I tried to set the alarm without the resistors today. However something is t right, please can you help. The PIR are working and motion sensitive (as red light comes on when moving in front of all). Keypad now has a power source (lit up), but not sure if it is responsive. When external bell...

I do. That’s fantastic! I’m waiting for my resistance connectors to arrive, and then I’m going to give it a shot. Will let you know how it goes. Thank you so much.

I just don’t know how to disconnect the keypad or the current box from the mains. I will take the fuse out though. Cheers

Thank you, the box and bits have disappeared, not even sure what make it is to find a manual. I will continue studying up, thanks

I have had a look. Just wondering 1. where does the bell go? Is it in the speaker +- sections, and leave the other 4 outputs. 2. The keypad section has 4 places, but there are 5 wires, any ideas? 3. The COMM A/T on the left (under the ac), what is this for? Can anyone help? thank you

Thanks Ken.

Hello, I have a burglar alarm that has been left partially set up for a long time. My PIRs are wired up (about 5), bell externally fitted and the key pad is in position - all wired by an electrician a few years back. I just don’t know how to finish it off. The panel looks like this Can...