Search results

Undo the pump flap at back one screw check the float switch isn’t activating and that it is actually pumping all water to tray funny how it worked first go but not second.

I thought originally the program finished but now shows pause icon ? You changed ntc below the lint filter ? Not the one in your picture

Also are you saying the fault has changed now since fitting the sensor ?

Have you swapped the sensor for the correct one as there a couple of different sensors on the machine that look the same have you tried the cycle again that worked originally?

Normally 2 on them, front one below lint filter or near the fan, I changed that one once as drying cycle was ending after 5 mins then tested it and it fixed it; so I would do that one first, the other is in base and can be hard to get to.they can be metered out for resistance and measured...

Check the reservoir if full it’s your pump 9 X out of 10 that was the fix

Ha ha you again

check if it has a float switch in the back normally the pumps go not pumping it to tray then the water rises and clicks the switch in reservoir Normally one screw in panel on back bottom on beko grundig etc

Is this is a condenser or heat pump, generally when this fault occurs it’s down the ntc sensor

That’s the conclusion I have come to as well with the location of the internal walls and where the cracks are think the same thing

Well they have been there for nearly 3 years since owning it that picture is the picture from the brochure when I bought it. When I moved in the gutters were dripping on front and back corners so had guy in who repaired the lead corners and said the gutters were ok didn’t need cleaning at that...

As requested

Nice example if cross lining below picture line in most old properties straight across the rail the cut the bottom one 20cm longer on skirting and into corners you can get nice butt joint across then wet the corners and top of skirt give it 2/3 mins then brush into place and press into corners...

sizing is the best way but last 3 rooms I didn’t have size one time so did without and had no issues and since then no issues as when I x line it rolls out nicely, but with the 1m lengths you only get 1 join below the picture rails, I have had a couple of times has issues with grit where I...

And the white bit you are looking at saying is water down the wall is the salts coming out behind where the water getting to from passing through the pointing above it see pics

I would say water runs down every wall lol yea it’s coming through the pointing above

Incorrect answer see the other pics it’s the pointing, we have already answered this are you just trolling me for a reason ?

Wayers that is correct you can,

.

Also the fibres in the paper strengthen the wall so will be the best option in the long run, I’m one room I didn’t fancy taking it back so there were some hollow sections I did a quick job of filling and not taking out, 2 years later still like the day it went up look into it