Search results

I think you gave answered my query Rob. I have the option of switching the dishwasher back to the mains supply. Thanks again.

So at the moment I have the large CWSC in the attic with one outlet going to the hot water cylinder and the other directly to the booster pump. Central heating is an unvented setup. outlet from hot water cylinder goes directly to pump as well. Outlets from the pump feed two 6 port manifolds with...

Rob I have the dishwasher connected to a hot water supply utilizing the solar panels to reduce energy consumption. Have done so since panels installed 10 years ago without any issues. I can easily switch back to the cold supply if I have to though.

Yeah its a positive head pump - its probably the solenoid in the dishwasher not allowing a strong flow of water past - pump reacts the same way if I open a tap partially - might have to connect the dishwasher directly to the attic expansion tank?

Hi - ITs a Techflo T3 - I think Stewart Turner manufactured them. With the dishwasher the pump cycles on and off every 1 second or less which cant be good for the pump. Was thinking a 5l or 10l pressure tank on the cold circuit would stop this?

Hi All, I recently added a 3 bar twin booster pump to boost the pressure to all outlets on my vented domestic water system. Its working out very well except the pump cycles on and off after flushing the toilet and also when the dishwasher is filling. Thinking of adding two expansion/accumulator...

Yea its a solar cylinder with twin coils and temperature sensor probes etc. Thanks again.

Thanks Tony - does that mean that if if you are installing a pressurized cylinder in a vented setup you would still require a qualified installer?

Hi All - have to move location of my vented hot water cylinder so am taking the opportunity to install a solar panel. I initially planned to change to an unvented system as most of the pipework is in the attic and got my hands on an unvented stainless steel dual coil 250litre tank at a good...

Hi zipper after last post put PCB back into the dishwasher and low and behold the dishwasher started heating the water again! So maybe a dodgy soldering that I did not spot or faulty connection. Has gone through 3 washes now and no probs. Will probably act up again,and I will check the...

I'm not that familiar with resistance/ohms etc but tried that NTC unit on an ohmeter today cold and meter moved to 5 ohms - did not try it hot - will check tomorrow. Thanks again

Ok - took Control unit apart...no obvious solder failures - looking like pcb unit replacement then or new dishwasher!

Thanks Zipper - will have a look.

Forgot to add PNC - 911 519 071 00

Hi All, Have a tricity bendix dishwasher model TDF222 - suddenly stopped heating the water but will complete a full cycle. Had a look around - it has a water heater on the intake pipe as opposed to an element in the sump - look this off and connected it to 220v briefly - heated up. Then...

Thanks oilhead.... :D

Hi all, I have just been offered a stove with a back boiler and am thinking of using it in the conservatory. However I am not interested in connecting it up to rads etc. Can a stove with a back boiler be operated "dry" without running water through it? Ta in advance.

Nothing like that on this boiler ,Tony - not a condensation boiler then.

Yea Tony, 35/80 IE boiler - I had thought it was a condensing boiler!. So - is there something else I can examine to try to rectify this prob?

Hi Baxpoti, No, bought and installed in Ireland - dont understand what you mean by burner low gas setting. Yea, runs on lpg.