Search results

It was, but just had an engie in and he said the PCB's had it. Says I'm looking at a new boiler since it's pretty old anyway. No it turns very well and shows the temps and everything

I got a green light now but the temperature doesn't go up and down - stays at 0 unless I turn either of the knobs (then it shows the temp of water / heating temporarily then goes back to 0)

Hi, Moved into a flat with a broken knob that controls the radiators. Estate agents were useless so was forced to do a self repair. Ordered new knobs and followed this procedure to the letter - Once I turned the boiler back on, it just says "0c" and no longer have hot water or heating...

You're right - it does. I plugged a hair dryer in and the furthest MCB on the left powers the socket - I'm surprised the leccy never even noticed! So it would just be a matter of moving that to the blank plate on the right one? I don't have the storage heaters, they weren't there when I moved...

Sounds like I need a few words with my electric supplier then! I would no doubt need to get the sparky in again since I'm actually renting. Here are my fuse boxes - I suppose the one on the left is the night rate circuit?

Hi, I recently had a fused spur plate replaced with a regular single switched socket, as the spur wasn't being used for anything (must have been an old storage heater which had since been removed). When the electrician first put it in it didn't actually work, and since he only came to replace a...