Search results

I’d only tested a couple of zones just done a check after your reply and zone 5 pir isnt lighting up……….when said it was working fine it was setting and unsetting fine and front and back door zones were picking up on entry and exit…….I assume that the reason for red light then….what could be...

Thanks for advice everyone…….today I did a factory reset and it all work fine now as it did before (apart from a red light flashing on one of two of the bell boxes)

Cheers Sparkymarka Where will I find that or those?

I did a power down and battery disconnect and it turned out spanner light from when sensor wires touched.No fuses blown. When put in user code to set it carries on bleeping as it does usually but then when it normally changes tone and sets it just carry’s on bleeping with zone 5 lit up which is...

Yes I’ve never changed code mate it’s still P9999 but when I press the P and last 9 it’s an error tone. Accenta G4 mini and the keypads 8EP416

Oh sorry

Can anyone help my alarm isn’t accepting engineers code anymore but its correct number. Also I have 2 bell boxes on each side of house the one has a red light and the other has flashing green

Can anyone help please I’ve recently converted my garage,I had to move 2 alarm sensors. I put it in engineers mode but while moving the sensors some wires may have touched. The alarm works fine but I want to omit the sensors in the garage when on night program……the problem is the keypad won’t...