Search results

Cheers, didn’t realise it would be that simple. Thanks again!

Hi, good people. I have two panic buttons fitted on my Scantronic 9752 & assigned to Zone 8 but don’t want to use them (wife keeps setting them off whilst dusting). What’s the easiest way of disabling them without affecting the existing set up. Many thanks.

Would you believe it. Found a PA in one of the bedrooms & it was pressed. I suspect it happened when I had the room decorated. The system has now exited Installer Mode & is showing Unset, displaying date, time & 9752. A big thanks to everyone for their help. I was going to give a special shout...

Ok. So did a command 21,1 & I now have a message Zone Open Z08 which is the PA.

Sparkymarka, thanks. Is this command 21 opinion 1?

Zones & Installation record

Photo of PCB

Ok. I think I did. Does that mean I need to do a full programming or will it work on the default?

Thanks for replying Handymanjo. I did a NVM to restore engineer & user codes. Having checked the zones they are default types for single system as per programming guide (page 3)

Hi, I have recently bought a property that has a Scantronic 9752 installed. The previous owner could not supply the user code so I reset the system. When I enter installer mode & then try to exit it 99, tick the keypad display is constantly scrolling Zone Tamper Z01-Z08. There are no alerts...