Search results

  1. J

    Number Plate Light

    I have a vauxhall vectra 1.8 sxi on a 53 plate. I noticed the other night that whan the car is unlocked the number plate light will stay on indefinitely (I presume) and will only go off when I lock the car. It also comes on if I open the tailgate only. Surely this isn't supposed to happen...
  2. J

    Pointing disaster

    I successfully laid some flagstones a couple of weeks back, barring a few I’ve had to lift and re-set, but my pointing didn’t go anywhere near as smoothly. I looked around at the various bits of advice on the forum and decided to go for a 3:1 building sand to cement, brushed dry into the joints...
  3. J

    Any concerns about outside wiring?

    Afternoon all I have 3 double external sockets (one of which is in my shed) at my house and wanted to make sure they are set up correctly, being as I don’t know who did them. I have a separate ring on my consumer unit for the kitchen sockets, of which there are four. Only one of those is...
  4. J

    Dodgy paths

    Morning all I have paths around my house which are surfaced with rough concrete and they look very dirty and tired, as well as being a bit jagged and painful if you fall. I really don’t want to be hacking them away and replacing them, so I was wondering if anyone had any ideas of what I can...
  5. J

    A familiar patio question

    Hi all I've read and digested a lot of the infomation out there on the web - most notably pavingexpert.com and also a lot of the posts on this forum regarding bedding mixtures. Thermo - who appears to know his stuff - recommends wet mortar as opposed to 10:1 a dry sharp sand/cement bed...
  6. J

    Stud Extractor

    Hi all Whan trying to change the ignition coil pack on my Megane Coupe, I came across a rounded hex bolt, which I really need to extract. Trouble is, somebody has obviously tried before and snapped off the tip of a stud extractor in the bolt. It doesn't look like it goes very deep, but I know...
  7. J

    undoing somebody else's bad workmanship?

    Morning My ‘plumber’ has made a bit of an error. He installed a shower, tray and quadrant enclosure for me and it’s leaking like a sieve. First he didn’t bother to tighten the trap (oops), then I find water pouring from beneath the curved rail that sits on the tray. I spoke to him and he...
  8. J

    Bottle trap leaking

    Hi all I have fitted a basin in my bathroom with a pop-up waste and it’s leaking. There’s a nut that screws onto the rear of the bottle trap, through which there’s a rod with a ball on the end. It’s this nut that’s leaking. I’ve replaced it in case the nut was faulty, but it seems to have no...
  9. J

    Dark blotches on tiles

    Morning all. I have searched the forums and can't seem to find an exact match for this problem I have recently laid ceramic tiles in my bathroom with undertile heating. I connected up last night and all was fine until the surface of the tiles started to show dark blotches where there are...
  10. J

    Dodgy looking circuit and lights not working

    Hi guys I’m new to this forum and there appear to be some knowledgeable, helpful people here. Great. I don’t know who wired my house, but I’ve seen something which confused the hell out of me. In the roof space above my bathroom I have a 30 amp former shower cable, which runs into a...
Back
Top